Search results

  1. Frdbronco8

    Brake pull

    Seeing if I can narrow this down before throwing parts at it. Pulls a little to the left on moderate to hard braking. If I let go the steering wheel will turn a couple inches. Does this mean anything (front vs rear) Also if I brake hard a few times it seems to stop doing it for a while. Sticky...
  2. Frdbronco8

    Lets see those loaded cargo racks

    Recently got a bestop tailgate rack it's about 20x40. Looking for ideas on how to load it up. Combination of storage bin and other things strapped down? Let's see your tracks loaded up how you use them!
  3. Frdbronco8

    Novak trans mount for tummy tuck

    Would like to have a flat and somewhat tucked skid but I have two problems. 1. I dont want to spend a ton and 2. I have an 01 that I swapped a Rubicon Tcase into. This means I have special clearance issues. The Nth degree skid had a bump out area for the larger tcase (even on the 01 model) and...
  4. Frdbronco8

    MetalClock 3.5 inch actual lift height?

    Anyone running metalcloak 3.5 coils and can anyone tell me the actual lift height they got with a 4.0 and maybe a winch out front? I have 2" bds coils (about 2.5" actual lift) and 3/4 spacers now. Fronts become unseated at full droop. The MC springs would have more unsprung length but I dont...
  5. Frdbronco8

    Transmission mount ideas

    Swapped a rubicon 241 transfer case and had to use spacers to raise the trans up for the mount to clear the tcase. Was thinking of putting in a Barnes 4wd 2inch drop skid plate and bolting the trans directly to it using insulators like these. Any experience or thoughts with something like this?
  6. Frdbronco8

    Track bar is binding after lift install

    I just installed a SYE (in the form of a 241 rubi Tcase) and a cv shaft. I have about 3 inch susp lift and 1 inch body. I adjusted the rear pinion angle and installed and angled track bar bracket on the axle side but it seems like the bracket angle is a little too much. Stock Track bar is...
  7. Frdbronco8

    Anyone run the Barnes 2” skid?

    Anyone run this? If so how much body lift and is it a rubicon? You have to make your own mount. I'm putting in a rubi tcase soon and was thinking of using the rubber mount to bolt the trans directly to this skid. They make special washers that are a ramp around the bolt heads so I wouldn't be...