Search results

[2022-08-14 - price dropped to $250] Hello, I upgraded my subwoofer and have the old one to sell. The sub is this model: https://www.crutchfield.com/p_575P3S210/Rockford-Fosgate-P3SD2-10.html?tp=111 and includes this grill...

Kicker including this style of mount is a huge selling point...

The dash pods I have do give you an enclosure, but its way too small. Most speakers are designed to go into doors, which are large cavities, bordering on being a free-air config. The .25 cu ft or whatever the pods provide is way too small, but I thought better than having the drivers in the...

Have you already purchased the gear listed, or are you in the planning stage? Whats the purpose of the stock head unit? are you planning to use it or is it just there to deter theft? if you want to fade between the front/rear you'll need a 4 channel amp. (If you don't, you can wire your front...

Resurrecting this thread rather than starting a new one. I generally avoid anything from Harbor Freight that runs on electricity or where failure results in a trip to the ER (or the morgue). But I see a couple of HF jacks recommended above, so I think I may make an exception. The links above...

Rockford, kicker, JL, alpine, and stereo integrity are the sub brands I’m most familiar with. I’ve never seen them recommend multiple channels for multiple voicecoils but I’m open to being proven wrong. I’m certainly not familiar with *all* brands or bestcaraudio.com or soundcertified.com. It’s...

I'd agree with this because I've never seen a wiring diagram with 2 channels, 1 for each voice coil. The most common configuration with 2 channels is 2 channels bridged, then wired to the sub with the voicecoils in series or parallel. There may be exceptions to this but I am not familiar with them.

No problem, hooking up only 1 VC of a dual VC driver is a pretty common error.

IT looks like that's a dual-voicecoil woofer in your diagram, but the amazon page seems to indicate it's a single voicecoil woofer. If it's a dual, you need to wire both voicecoils, either in series or parallel. This is actually why they're designed that way: with a dual 2 ohm voicecoil, wiring...

Anyone know of a good overall guide on how to rust proof a vehicle? I've got my TJ and another project vehicle ('60s ford product) that are going to need protection from the elements.

Thanks! This group is a well of knowledge. Mostly useless for day to day life, but it's a deep well, nonetheless.

Hey - what's with those milk jugs? Are they stock or aftermarket?

If you live near a target and have $20 you can also have your own Jurassic Park Jeep.

I built these out of 1/4 ABS. 2 inch hole. Alpine R-series Tweeter. Made a huge difference from down below.

melt it. go slow. Alternatively, I cut a notch in mine and built a 'bump' out to give the magnet clearance. If I had to do it over again, I'd try the melt method first (then cut a notch if i screwed it up). There's a bit of clearance between the top of the enclosure and the coin tray in the...

Ha! - I thought it was different than most. Not a lot of mountains in this part of Florida but I do take it off road if 'off road' means driving it down the beach... :LOL:

Maryland. I remember when that happened. Poor dude. Even the cops were clueless.

Morel Hogtalare. Nothing else comes close if you want accuracy. Looks like they're back in stock! https://www.crutchfield.com/shopsearch/morel_hogtalare.html

Looks like it's the seat itself, after doing some proper troubleshooting. I should have clued in as its gotten worse as I've put on the COVID-20 pounds or so over the past year.