Search results

Have been using this since ordering it in bulk in 2021 thanks to the advice of @Jerry Bransford. Went to order more today for my next oil change but it seems to no longer be available. Can anyone confirm if it is in fact discontinued? If so, what is your choice of oil and why, especially if you...

So I’ve researched the cold start threads and they all seem to be on cold days. It’s 90F here today so here goes. I typically only take it out for a cruise on weekends but the weather was nice so I figured why not for a quick trip to the store. Anyways, as soon as I started it there was a loud...

Got up bright an early this morning to get the LJ cleaned up for a Jeep event today. It was my little boys first Jeep event and everything was going great until it was time to leave. As we approached the Jeep I saw someone taking a pic of my license plate and I instantly knew something was...

Found a small puddle on the garage floor this morning and this is the only area that seems to have fresh looking oil on it. Looking more closely under the Jeep, I see some blow by staining on the trans skid and front side of rear diff presumably from where it’s leaking when I’m driving. Jeep...

Pics here https://www.chelseatruckcompany.com/storage/app/media/models/wranglers/ChelseaTruckCompany-BlackHawk-2017-web8.pdf Info here https://www.chelseatruckcompany.com/models/wrangler 🤦‍♂️

So we are constantly posting (and laughing) about unfortunate JK’s, JKU’s etc that ride the rails of douchebaggery so I figured why not start a douchebag of the day thread. It’s all in good fun so hopefully no one will get butt hurt over it. If you see something that makes you think “Haha, look...

https://www.mahindraautomotivena.com/roxor

Wanted to degrease/clean them up a bit. Any harm in in spraying them down with GUNK and rinsing?

https://rover.ebay.com/rover/1/711-53200-19255-0/1?icep_ff3=2&toolid=10001&campid=5337789113&icep_item=323471063945 Looks like a bumper @Chris would have 😆

Hard to believe there are 3 for sale around town right now https://www.graypointautomotive.com/vehicle_pages/1j4fa44s16p766534-2006-jeep-wrangler-unlimited-used-sport-utility-2-dr-winterville-nc.shtml

https://www.brown-wood.net/VehicleDetails/used-2006-Jeep-Wrangler-2dr_Unlimited_LWB-Greenville-NC/3432039933

Daughter had camp today which was about 45 mins away so I figured I’d bring out the Jeep for its first cruise since last year. Got on the highway and didn’t know what to watch...the gas needle going down or the speedometer continually dropping unless I flicked the OD off switch. Sigh. Guess it’s...

So when I did the tear down the inside of the block where the tstat housing and water pump connect were really rusty looking, especially the water pump inlet. I assume this is from the PO using non distilled water at some point in the Jeeps life, possibly always? Who knows? Should I drain the...

Appears to be a base model. Not impressed like I thought I would be. Too long, too low, TOO JKU. Just meh.

So I’ve had many 4.0 Jeeps (not all Wranglers) and for the most part, they have all sounded the same. That was the case for my LJ too until this evening when I took it out for its maiden drive after completely overhauling the cooling system. It’s very bizarre and I’m not sure how to explain it...

I am 95% done installing my entirely new cooling system in to the LJ. I went ahead and changed the trans fluid lines that hook to the bottom of the rad and that’s where my question arises. Is there a reservoir inside the bottom of the radiator that will need replenishing or does the fluid just...

I currently have it clocked horizontally (see pic) with a raised “tick mark” facing right and “54mm” where it’s stamped in to the metal facing left. Should it be vertical, horizontal or does it even matter? I know on stats with a bubbler the hole goes at the top which therefore guides you on...

I pile all the dinner dishes to one side, bring in dirty Jeep parts and wash them in the kitchen sink. 🤣

Was about to put on my new Mopar water pump and realized that the gasket it came with had an extra hole. Is this normal? The old one was unrecognizable so I don’t know if it had it or not. The gasket has a small bead of something on one side and I honestly thought that side would have gone...

Received my new Mopar overflow today and noticed a difference between my old one and the new one. At the top inside the filler neck there is a vent that leads to a spillover. On the new one the spillover is closed at the end and on my old one the spillover is open at the end. It appears the...