Search results

I need to overhaul the front diff on my 2005 TJ auto I would like to order all the parts I need prior to starting the job. I normally purchase my parts from RockAuto but it is difficult to identify the exact thrust bearings and seals I need for the pinion. Can anybody help with part numbers please.

My starter motor sometimes wouldn't run. So I removed the stater motor assembly and started dismantling the components. I found one of the magnets in the electric motor (part # 56041914AC) had shattered and small parts of the magnet had attached themselves in various places. I know I can buy a...

The blower on my 05 TJ is showing all the symptoms of faulty resistor. Only goes on one speed (second one) but blows at full speed. I have pulled the resistor but all the coils look fine. Can the resistor unit still be faulty despite it looking ok? Cheers Bob

My 2005 TJ has a 2" lift and done 60K miles and the lower control arms are looking very beaten up. I am happy with its handling and dont do any hardcore wheeling. Should i purchase another set of standard arms or something else?

I need to add ATF to top up my auto trans but ATF-4 is not available any where in New Zealand currently. Is there a substitute?

I need to add ATF to top up my auto trans but ATF-4 is not available any where in New Zealand currently. Is the a substitute?

This is a pic of the ujoint that was on my 2005 TJ front axle. I cant seem to be able to correctly identify the part number. Can anybody help? Thanks

I need to remove the diff on my Dana 30 to replace the axle seals. I have marked and removed the bearing caps and removed boih axles. The diff carrier seems to be stuck. I just cant get it to budge. What technique do you suggest i try to get it free.

My 2005 TJ has a 42RLE transmission. I have recently been towing it on an A frame. Prior to towing I always put the transfer box in N and the Auto trans mission in N and have towed it many times like this. Some times up to 500 miles at speeds up to 60mph. When I arrived home after this last...

I have removed the 10mm centre bolt but the front clutch plate will only move forward about 1/4" then stops. It feels like there is a circlip stopping it but no videos for the MC 447300-713 clutch removal show any retaining clips. The front plate is supposed to just slide off once the 10mm is...

Is it possible to replace the a/c compressor clutch on a 2005 TJ without having to remove or disconnect the a/c compressor. I can get my 10mm socket on to the retaining nut but am unable to prevent the clutch from turning.

Last weekend I was off road and something hooked into my Transmission cooling lines and tore them out of the bottom of my radiator. Obviously this destroyed the radiator and I was immobile. It was not particularly difficult terrain. I bellied out on a few clay high spots which I eventually just...

My link bushings that the rear Sway Bar fit into are worn out. The TJ parts list do not show a separate for this only the complete link arm. (3 52088 896AA2 Link, Sway Eliminator) Can I replace the bushing and if so can you tell me what are the dimensions. Thanks

Will fitting a Rubicrawler place addition loads on the drivetrain components?

My yoke failed today and I need to purchase a new one. There are none in New Zealand and would like to purchase from RockAuto but can't find the part number in the catalogue. Can anyone help me locate it. 2005 TJ Wrangler 4lt

I'm in the process of installing my new Rubicrawler into my 2005 TJ. I am trying to remove the spud shaft using the recommended custom puller method but the spud shaft refuses to break free. Do these shafts normally require a lot of force to break them free?

I'm fitting the Rubicrawler on my 2005 TJ primarily because wheeling in our areas are very steep, and some are for long durations so its hard to keep the brakes cool. Also I am always catching up on those ahead of me on the trail if i rely on my engine breaking (Low 1) I have the only Jeep in...

I guess I already know the answers but, my rear universal joint is toast. Is it ok to remove the complete driveshaft so I can drive to pick up the parts? I know it will be front wheel drive only.

Im sure this has been asked before but I can't find the answer. I can't find any brands of ATF +4 where I live. Is there any alternative I can safely use?

The boots on my 2006 TJ ( done only 50K miles) are cracked. There is no movement in the steering linkage. I know that providing I grease these regularly it will keep dust and grit out of the joint. The problem I have is that a few months ago I was a bit careless when greasing. One pair of...