Search results

When setting up my Dana 44 rear axle, I set the pinion too tight causing a ratcheting action when rotated. I adjusted to correct this , and now I have a howl. Did the too tight event cause my howl? THANKS

Will later model Rubicon front axles fit my lj without too much work ?

Im looking to regear my 04 LJ Dana44 with 3:73 gears to 4:88s. Will I need a different carrier? THANKS

Is a friction modifier needed for my limited slip rear Dana 44 in my 04 LJ ? Thanks

Need a little help,please....again. My 04 LJ 150,000 ish miles ,auto trans, BFG all terrains has rattles coming from area of front suspension both sides when easing along gravel roads 15-25 mph. This stops when I accelerate or brake. I`ve looked and wiggled while up on my rack,with no success in...

Just finished replacing carrier bearings and pinion bearings in my rear Dana 44 in my 05 Rubicon .Now my back wheels are locked together. What is most likely thing I have done wrong ? THANKS

The rear dana44 in my 05 rubicon with 6 speed and 121,000 miles is noisy. After putting it on my lift in neutral, I spun one rear tire, the other rear tire spun opposite direction (expected) but the drive shaft spun only intermittently. Is this normal ?

I had a small vibration in my 04 LJ at about 50 mph . Installed a new generic trans. mount and now I still have the same vibration plus vibration at idle .Does anyone have a clue what this is ? (Auto trans,4,0,stock 373 gears and 32'"BFGoodrich All Terrains with no lift) Thanks

I am replacing the rear wheel bearings, seals,etc. on my 05 Rubicon . After pulling the axles, I could reach in and work the bearing races out by hand . Should I be concerned about this loose of a fit? Should I Loctite the new races in ?THANKS

Can someone who has one tell me if there is any real performance gain from a cold air induction setup ?