Search results

Great info, thank you. For what I'm using it for currently, I'll keep it simple with the 4 pin. Just watched some crazy videos with folks trying to tow too much....

Definitely getting one of these thanks!

That's what I was originally looking for, thanks. I'm liking the magnet option though.

Thought you were just talking about the attachment. Thanks for the confirmation.

Ok thanks, any worries about the cable being crushed like that?

I misread your question. I think the outer wrap that got pulled tight happened to be overlayed with the end of the cable at the attachment. It cinched it down incredibly tight through a couple layers on the spool and was pretty hard to unspool.

I had the cable hook attached to a shackle that was on the flat tow behind emergency cable attachment point. Bent that pretty good! In this pic it's just got a Velcro strap holding it in place.

My cheap Amazon winch got a mind of it's own and decided it would "pull" for a split second every now and then all by itself. So, before I figured out what was going on it had pulled the cable VERY tight on the spool and actually detached the end of the cable from the anchor point. The...

Anyone have any suggestions on a mounting bracket or something for the 4 pin trailer wiring connector? I'm looking to clean up the mess I currently have and I can't seem to find any mounting brackets or anything for the 4 pin connector. What does everyone do, just let the connector hang under...

Hello, Did you find something that worked for this. I'm also looking for the same thing. Something with a 1-1/2" pad would be perfect. My lock doesn't work anyway so I'm just looking to cover the whole thing.

Ok, I'll look for it there. Thanks

I did a pretty thorough search, and couldn't find anything specific, so apologies if this is already listed somewhere. Speedometer stopped working, engine light came on and threw a P0500 vehicle speed sensor code. I can't find any information on the correct replacement sensor, where it's...

Thanks. I found the issue. It was pretty obvious once I was able to stand in front when it made the noise. I was looking at the starter etc but it was actually the winch. For some reason it was engaging for half a second every now ant then. Bound itself up pretty good too. I disconnected...

TJ's been sitting for 5 months in the garage during winter. Charged the battery and it started right up, however I now have a "clack clack" noise every few minutes, it happens with the key out of the ignition AND when it's running. Didn't take it on the road but forward/reverse seem to work...

Yes thanks. I'm slowly making my way through the 40 pages. I'm ordering the other Walker from Rock Auto(y)

Hey guys, I just got the P0138 code. O2 Sensor Circuit High Voltage (Bank 1 Sensor 2) I'm not having any luck finding the NGK / NTK replacements. Does anyone still have a good source for these? Edit. Found the right post on here and looks like the Denso 234-4078 is the correct match for the...

Thanks everyone for the help. Problem solved ! I cleaned the throttle body and sprayed a little in the IAC intake before I tried to start it. That was enough to do the trick, it started right up no problem. I spent some time and used about half a can of cleaner with it running making sure...

Thanks, I'll Youtube the IAC valve location.

Hey guys, I did a search but did find this problem posted. I parked the my 97 6 cyl in the garage for the winter. Went out last week and charged the battery. Tried to start and it would almost run but wouldn't start. It will start if I give it gas while I'm cranking it. It will only stay...

I found this used one. https://deadjeep.com/products/90-06-wrangler-tj-yj-dana-35-driver-rear-axle-shaft?_pos=2&_sid=dcc17f671&_ss=r What do you guys think?