Search results

Hey, unfortunately my TJ is starting very bad, sometimes I have to cycle the key again so that it starts, if the engine starts, it runs very rough for the first 20-30 seconds, as if it's not lighting the fuel. Since two weeks the idle is getting worse and worse, I can push down the throttle but...

Thanks for your reply, where could I get some OEM wires? Best regards

That would be great (y)

Hey Jerry, i want to replace my spark plug wires, distributer cap and finger, do you have any recommendations. I live in Austria and its really hard to find good quality parts. Are there parts out there which are equally good as the oem ones? My TJ is a Sport 4.0 from 1997 Best greetings from...

Nice do you have the name of the accel wires, i dont really have the problem because i drive 2000 miles a Year

Thanks for the recommendation, do you have any problems with your radio?

Hey Guys, i want to change my old spark plug wires, they are red and id dont know if they are original. Does any one know where i could get oem wires or are there good after market one out there? Same for the distributer cap and finger. My Detailer Washed the engine bay with a pressure cleaner...

Hey Guys, I was accelerating out of a tunel and there was a slight incline. I was pushing the throttle all the way down too see how long the 4.0 pulls in first gear. Suddenly i hear a clong noise just for a split second and i loose power, i realease the pedal and step slightly onto it again...

@Jerry Bransford I have another question, I bought a serpentine belt with 2000 mm and my TJ no AC with Power steering has a 2004 mm belt. Is it ok too use the 2000 one?

Ok that sounds good we have around 100 degrees Fahrenheit here so 10W40 is probably a good option, my dad used from the beginning full synthetic oil should I stick too with it or switch too a half synthetic or even conventional Motor oil. And what do you think about Mobl1 my dad used it also...

Hey Guys, I changed my oil a couple of moths back an I think my dad put in 10W40. Should I put 10W30 back in? Best regards

Where can i lube them, is there a specific spray or grease for that

It was clearly angry with me :ROFLMAO: But now the jeep has a new fuel pump, new brakes callipers pads, all new fluids. I just have a issue with the engine oil is 10W40 fine because the Jeep has just 36.000 Miles

surprisingly not an issue, speaks of good Quality. Yes the rubber is hard and the grips isnt that good but not issue with flat spots or cracks in the rubber.You have too know my dad bought in 2011 new tiers, new discs and pads. Than he parked the jeep for 10 years

Yes, the right side cought fire and pulled heavely too the right side. I orderd a new pair of Rotors and Pads with two Callipers

How would some one doo this without running the mater cylinder dry. Is it possible too empty the zylinder complety and then fill it up again and then bleed the brake system

Yes i changed it, i am a bit worried because my vather had 10W40 Oil in the garage. So i used it, is it ok or should i see if i can get a 10W30 Oil. He ran from the beginng vull sythetic oil but he doesnt remember if it was 10W30 or 10W40. For the break problem, i orderd a set of raybestos...

Hey Guys, today i drove the tj for the first time in 10 years. Strangly the brakes a constantly applied. I can realeas my foot on the hill and the tj stops. Whats the cause for that? The brakes were somoking when i stoped. Whats the cause for that best regards lennart

Hey Guys, my red airbag light is on AIRBAG whats the cause for that? Best regards Lennart

So I checked the piston and the inner Surface of the calliper no corrosion, the break fluid is clean. I think that I am going to clean the piston up and put it back in