Search results

I have not found any info on what the optimal temps are for an ax15 transmission, does anyone know what temp range is perfect for the AX15? I am not having an issues, simply out of curiousity. Thanks!

So I have had these issues for awhile now, but have gotten tired of continuing to top off my coolant resivoir every few weeks. The issue is, my coolant is disappearing, been like that for awhile(several several oil changes). I do not see any milky residue under my oil cap, or on my dipstick...

I have looked at almost every forum trying to find the exact issue that I am having, but am posting because I had no luck… My steering is somewhat sloppy, has an issue whenever I turn left, it will making a creaking noise, doesn’t do it when i turn right, only left. I got my girlfriend to turn...

Hello, I have an 02 4.0 that I have come to some very weird issues… I replaced the harmonic balancer, as well as the entire cooling system… When doing this, coolant went everywhere when burping the system, today… I washed the engine compartment, drove it, and low and behold… a pending 0305...

I am not happy with the aftermarket radiator I purchased awhile back, and I want to find a good quality mopar radiator to put in before it gets too hot, i’ve searched several sites, ordered from a place called vivid racing, because they are based in my city and I thought why not… Long story...

Hello all, I am about to change the fluid in my dana 44, i have an open carrier, no locker(used to have ARB till it blew) so I still have an ARB cover. It’s a 2002 TJ, I am just confused on how much fluid I would need, I fear overfilling and it ruining my outer seals, as I just did those about 2...

Hello all, as of recently, I have been in full service mode.. some things done in the past 6 months front driveshaft rear driveshaft(both tom woods) front disc brakes(rotors and pads) axle shaft u joints timken wheel hub replacements rear drum brakes full grease of all zerts After doing...

Another issue has occurred in my drivetrain(90% sure). I’ve noticed recently that after longer drives, 15 miles or so i get a faint squealing/rubbing noise at low speeds. It doesn’t happen after short drives, and if i turn the jeep off for about 5 minutes and get back in, it stops again. Only...

To start off, my tj is a 2002 4.0 with an ax15 and NP231(swapped ax15 when my nv3550 blew up) with a tom woods rear drive shaft and a SYE kit. I decided to change the rear u joints in my driveshaft after feeling some play, i replaced 2/3 of them, the 2 i replaced were the outsides, not the one...

Sucks to be back with another thread so soon, but I recently rebuilt my transfer case, and pulled the speedo gear out to notice the whole housing was broke, besides the point…. I bought a new speedo gear housing, and the o ring leaked brand new, I tried to replace with crown O-rings, they leaked...

So i’m having a little trouble, I haven’t done any work on my dana 30 with the ARB cover and locker, and I don’t know the exact fluid to use, ive heard 75W-90, 75W-140 and 85W-140... That’s a huge range. Also am not sure what the proper fluid capacity is in a Dana 30 with an ARB locker and cover...

So, i’m new to this thread, but i always use it to look for solutions to my own personal issues.... Anyways, I am having trouble figuring out an issue where after my jeep has been sitting over night, it will continue to crank for 2-3 key cycles(but at normal speed) i have checked fuel pressure...