Search results

Will ship for $20. Still in package.

I already have the Morryde Tailgate Reinforcement Kit installed: https://www.morryde.com/products/tailgate-reinforcement-kit-2/ and recently picked up some Corner Guards from Poison Spyder and am wondering what the best way to do the install would be. I read on a thread that Mr. Blaine did this...

I currently have the Smittybilt roof rack, but am not a fan of it. I only have it to carry the occasional ladder (rarely), and my paddleboards and kayaks (10 times a year or so). I would like to now remove it as it rattles around and is heavy, but still want to have the option of throwing a...

No damage. Never even used. Open to shipping. PM me zipcode if you want shipping and I will let you know how much.

Anybody running this bumper? I emailed them and they said it is 28lbs, which seems to me to be very light. Could that light of a bumper compromise strength and durability? I am looking for something that can give me a bit better departure angle (while maintaining recovery points and a receiver)...

Hi, I have attached a video below of a clunk/knock I am hearing when going slow coming from the front driver wheel area. I assume the noise is there at higher speeds as well just less noticeable due to other louder noises (wind resistance, humming MTs). In the video I am coasting with the motor...

https://www.facebook.com/marketplace/item/1347639899354190/

Hi, I recently finally got around to installing the Currectlync steering and noticed after I installed everything that I am now getting a drip from the bottom of the steering box at the pitman arm. I had my wife turn the steering back and forth to each side and noticed that there is no leak at...

I know a lot of members here have done the big brake conversion. I have all the take offs in boxes in my garage. What did you all end up doing with them? In the past I have had a general lack of interest in OEM take offs in FB Marketplace etc. I did a brake job (new rotors and pads) last year...

The spare has never touched the ground. The other 4 have about 2000 miles on them and just a couple mild trail runs. No damage on any tires. Manufacture date code 3321, purchased in Nov. 2021. Pickup in Gilbert, AZ.

Nothing wrong with it. Ended up swapping it out for a SwayLoc.

Hi, I am looking into putting in upgraded 27 spline front axles shafts in my Dana 30 while I have everything apart to replace the U-Joints and Ball Joints and have read on this forum that Revolution is a good way to go. Is this the correct set up...

Installed for less than a year. Located in Gilbert, AZ. $220

Hi all, My TJ sits on 31s (and I have no plans to go bigger anytime soon) without any aftermarket lift and I want to give it a bit more performance offroad. I had been planning on doing a 2" BB and replacing the stock shocks with RanchoRS500x shocks, but seeing as this is the original...

Hi, Been stuck with a no-start issue the last few days and can't figure it out. (Jeep started right up until I swapped out the clockspring). It is not an ignition issue (switch or actuator pin which I read to be likely culprits) as I have taken the ignition switch off the steering column and...

Hi, I just replaced the clock spring in my 99 4.0 because I had no horn and the airbag light was on. Good news, that is all taken care of now. However, now that I put everything back together the engine will not turn over. Nothing happens when I turn the key. I have triple-checked the battery...

Hi, New to Jeeps (bought my Jeep about a month ago) and have really appreciated all the advice and guides I have found on this site. I just disconnected the battery on my 99 4.0 when I was replacing the spark plugs, spark plugs wires, distr. cap and rotor and after reconnecting everything, I...