Search results

  1. chudlet

    ARB Bulkhead Fitting Recomendations?

    I need to run air lines from my ARB manifold to my new lockers. The solenoids come with the easy press in fittings below (yellow). The diff bulkhead fitting kits come with both the easy press in fittings and the ferule capture setup (green). What are the pros and cons of going either way at...
  2. chudlet

    Caster adjustment advice?

    Hey folks. I was looking to dial in my caster a bit last night because my steering is ok, but "light" doesn't really return to center as I would like and came away with questions vs a done task. Setting pinion angle on the rear was easy because the diff has flat spots on the back to measure...
  3. chudlet

    Drive Line Measurements Question

    Just double checking my sanity and measurements here. I just put in 4" RJ springs, the Ultra High UCF skid plate and JB Conversions SSSye. So effectively my drive lines are seeing ~ 7" of lift. I have not changed any pinion angles yet. I don't see that changing the DL length more than 1/2"...
  4. chudlet

    AtoZ Fabrication back on line!

    Hey guys, I may be a little slow on this, but the last several times I have looked for AtoZ Fab, I got a "coming back soon". Today I found https://aidanparker.io/demo/atozfabrication/ . Looks like his is back! Admittedly, back may be an over statement I tried using the site and it was not...
  5. chudlet

    Chudlet's First TJ

    Hello All. Just a quick introduction and start of my build thread to keep things documented as I change them. Been in a Jeep off and on since about 1990, two CJ's and daily driven XJ. My last was a '76 CJ 5 that while I had the drive train pretty set, the body succumbed to rust so bad that...