Search results

Saab, The small vent tube line was not plugged. There is no clog or obstruction in the filler above the check valve. What do you mean by steel of rubber fillers? I did use a camera. NO Plugs. There is a slight kink in the rubber hose between the neck and check valve. I would have to...

What is the GM fuel hose fix? I don't have a flapper in the hose!

Ok I'm back with what I found out when I dropped the gas tank again. Dropping the tank this time I found the check valve was not stuck and I was able to move it easily up and down. So I performed the smoke test on the vapor tubing sitting on top of the tank as Saab rquested me to perform...

Sab, Wow, you did a lot of research. I appreciate all you've done. Is it possible a vapor lock could cause my problem? It looks to me like I have to drop the tank again but I will hold off until Winter. I will keep you informed. Thank you again for your help. Tom

@sab, I disconnected the hose from system as you recommended. Unfortunately, the gas valve still kicks off, so the problem is a hose above the gas tank or at the filler nozzle. Can I blow air from a compressor through either of the hoses to see if that fixes the problem? I doubt if the rollover...

I have previously indicated that I dropped the gas tank on my 2005 TJ and fixed the rollover valve. I am still getting code PO457 Gas cap leak. I replaced the gas cap, but know change. After all that, when filling the gas tank, the handle valve from the gas pump kicks off prematurely...

My 2005 TJ oil pan has a few lumps protruding and I was told that over time, rust causes these to occur. So my question is, Can anyone recommend where I can purchase a replacement with the seal gasket and drain plug for a reasonable price. thank you. TJ

Bret, i just got done fixing the rollover valve in my 2005 tj. I had to drop the gas tank & sand off the 3 sets of ridges. Not an easy job but its done & filling up is back to normal. TJ

I recently replaced the fill neck assembly on my 2005 TJ but the gas valve keeps kicking off when filling. I had to cut the hose (length) that runs from the new filler neck to the gas tank to eliminate a big kink. I have reduced the size of the kink drastically but I don't think the smaller...

I want to obtain a little more power on an initial acceleration and going up hills. By replacing the 55mm throttle body with a 62mm bore throttle body, will that accomplish that? Is there any other suggestions out there without spending a significant amount of money. Can the PCM be programmed...

Hill, purchase a code reader. They are inexpensive. What you can't see, the codes will tell you what is really wrong with your TJ.

Chris, I am glad you recommended Wrangler Fix to me. They did a great job fixing the circuitry within the ECM. Thanks Again. Tom Jensen

Mark, I am glad I sent you my ECM to fix. So far after 2 weeks the faulty O2 sensor indication has not shown up. You did a great job fixing the circuitry within the unit. I will recommend your company to other folks. Tom Jensen

Chris, I P0032, P00338, P03352 & P0058

Folks, After replacing all the O2 sensors, I am still getting 4 alert codes indicating High Control. The resistance for each sensor is good. It looks like the problem could be in the ECU. I'm wondering if anyone agrees and if so what should I do. Can I send the ECU out to be...

I found what you suggested on line and purchased the set. Looks like an exact replacement. Thanks. Tom

No your good. I found the entire unit on line and as you stated, it was inexpensive. Thanks , Tom

About a week ago I posted about my headlights on my 2005 TJ whether in low or high beam the blue light on the dash would always be lit. That has been fixed. After installing new headlights the adjustment screws to adjust the beams left to right or up & down, the torx part of every screw is...