Search results

  1. raycer12

    PCM, wiring or grounding issue?

    @Wranglerfix I sent you a PM with the order info. Thanks, Ray
  2. raycer12

    PCM, wiring or grounding issue?

    Thanks Mark @Wranglerfix I wanted to try to rule out other possibilities first. I don't usually just swap out parts to try and find the problem unless they're a cheap part that commonly a problem. The thing that makes me think it's not the pcm is the stereo issue. Although the headend uses the...
  3. raycer12

    PCM, wiring or grounding issue?

    I put the old pcm back in and ran it for a good 1/2 hour with no problems but I've had that happen with the new pcm a couple of times. Plus the original Tps problem with the old pcm was never solved. Going to run it a few more days and see what happens but I'm running out of ideas.
  4. raycer12

    PCM, wiring or grounding issue?

    Tinned copper makes more sense than aluminum. Does that mean it doesn't supply any real dc ground? Just pulled the Jeep out of the garage into the snow covered driveway and after idling a few minutes the volume on the radio cut out and my volt gauge jumped up. The Torque app doesn't give...
  5. raycer12

    PCM, wiring or grounding issue?

    I've been having some problems with my Jeep for several months now. I have a 2004 LJ. The problems started at the end of September. The jeep stalled at a stop sign and the check engine light came on. It stalled a few more times on the way home and when I checked it I got a P0122 -throttle...
  6. raycer12

    How to sound deaden the interior of your TJ

    I think I'm going to add this to my remote starter project after Christmas. I stumbled upon some rocker panel carpeting a while back when I was looking for floor mats. It looked pretty good. https://www.factoryoemparts.com/1997-2006-jeep-wrangler-rocker-panels-factory-fit-carpet-22527-160-1053...
  7. raycer12

    How to sound deaden the interior of your TJ

    I noticed you wrote that you can't spray out the tub. Made of butyl rubber with a foil top layer I would think this wouldn't be a problem. Is there a concern about the adhesive not holding or am I missing something?
  8. raycer12

    raycer12's 2004 Jeep Wrangler Unlimited

    It's the 2" OMETJHKS lift with 33x10.50x15 tires. It actually raised it about 2 1/2". Also bought a 1" body lift but I have no tire rub so I haven't installed it yet.
  9. raycer12

    SOLD 4 - 30x9.50x15's in MA

    4 Cooper Discoverer AT/3's with just over 5, 000 miles on them. Located in Cape Cod Massachusetts. Bought last summer and replaced this spring with 33's. $300.
  10. raycer12

    Subwoofer in tailgate anyone?

    That does look good but my seat usually isn't in the Jeep. I'm probably going to stick with my original plan to put it behind the rear wheel well. It looks like there's plenty of room back there in an LJ
  11. raycer12

    Will I need to re-gear?

    I'm not saying 3.73's are ideal for 33's just that I didn't notice much of a difference from the stock tire. Again this is mostly street driving on flat earth. I don't do much highway driving in it if I'm going on a road trip I'll take my wife's hybrid. And my off roading usually consists of low...
  12. raycer12

    Will I need to re-gear?

    My 33's only measure about 32" as well. But my 30's were only 29... The 10% is based on diameter as well as my speedometer. With my speedo at 60 mph on the highway my gps says 66. 10% difference. A 30' tire has a circumference of about 94", a 33' tire is about 104". So every revolution of the...
  13. raycer12

    Subwoofer in tailgate anyone?

    Had my spare tire off my lj today to figure out what I have to do to mount a 33 inch tire back there. I've been planning on putting a subwoofer behind the rear wheel well on the driver's side. I was looking at the spare tire mount and I was wondering if anybody's ever put a sub in the tailgate...
  14. raycer12

    Will I need to re-gear?

    I have a 2004 unlimited with the 3.73's and I just put on 33's with the 2 1/2" OME lift and didn't notice much of a difference in driveability. The 33s are only a 10% increase over the stock 30s. To keep your RPMs the same you would only need to change your 3.73s to 4.10s (a 10% increase). I...
  15. raycer12

    What did you do to your TJ today?

    Pulled my 5 1/4's out of the roll bar pods and put them in the dash ( had 4x6's there) and installed 6 1/2's in their place. Stuffed and sealed the pods and put in led's. Made a huge difference. Have a 45w x 4 Sony amp feeding them.
  16. raycer12

    raycer12's 2004 Jeep Wrangler Unlimited

    Just added an OME lift and 33x1050 KO2's
  17. raycer12

    headlights not level in housing

    Both of my headlights are at an angle. The drivers side a little more than the passenger side. I pulled this one apart a few months ago and the bulb is sitting in the housing correctly. Anyone else have this problem? I'm thinking I may have to remove the housing, drill new holes in the radiator...
  18. raycer12

    What did you do to your TJ today?

    Got the new 33's to go with the OME lift I installed last weekend.
  19. raycer12

    Help choosing between two speakers

    I always go and listen to speakers before I buy them now. Bought some speakers several years ago because the Spec's look good and hated the way they sounded. Go to a Best Buy or local car audio store and listen to different speakers. Even two models from from the same manufacturer can sound...
  20. raycer12

    What did you do to your TJ today?

    Finished the install of my OME lift and JKS front track bar and disconnects. Gained 2 1/4" in the front and just under 2" in the rear. Still a little too much rake. Off to get the 33's tomorrow. Before