Search results

How does the Savvy transfer case armor come out? I thought you could take the plate off,leaving the transmission cross member

Are you supposed to rotate tires if your running beadlock wheels once the outside of wheel becomes scarred from rocks. Does this throw the tire out of balance? Do you need to balance beadlocks in the first place?

I need a bolt for the latch (female) part of seat belt. I am finding to many different sizes. 2003 Rubicon

How do the big YouTube channels afford to do the off road thing? Sponsored?

Why are there two different sets off brake pad clips? I have one set with the calipers and another different set from the brake pad box. The instructions are very unclear pertaining to brake pad installation. Hard to tell from a blurry picture in the instruction manual, which seems out dated...

The older I get, the less I want to crawl under my Jeep. Are there any hydraulic lifts for my garage that you would recommend?

So, I have a 4 inch lift and run 33's. I'm replacing old springs with new Currie springs which are taller. They cover a 4-5 inch lift. Will this cause more length in my control arms? Or does it just add more compression for the suspension?

So I'm replacing springs and shocks and two new control arms on front axle. Removed front driveshat off the front diff and it will not extend back into the u joint. It's stuck bad. Is this a common problem?

I am upgrading my coil springs and shocks. Is there an easy way if removing overspray form aluminum??

I finally bought my UCA'S to go with the rest of them. My question is about the cutting and welding for the new bracket which I have. That is only for the passenger side right? Sorry if this is a silly question

Trying to order the 15 inch kit. Gave all my info and cc and nothing is going through!!

If I want to run 35's, what setup would you recommend for a 1998 4.0, 5 speed Sport with an AX15/5 Speed manual transmission?

I'm learning this website all over again. My question is. Can I put a supercharger on My jeep since all my pistons were replaced a couple years ago? 1998 Sport 4.0

Why is my horn going off when I am replacing blown fuse for it?

https://www.caranddriver.com/news/a27572940/diesel-jeep-wrangler-spied/

So after roughky 20,000 highway miles my KO2'S are almost done. I figure this winter I will replace them. Any suggestions on an actual highway tire in the 33 inch range? I still have my rims for an offroad tire and don't mind swapping them out for the weekend Beach run. This is my daily driver...

I was curious if anyone knows if an A/C compressor from a 2001 cherokee HO 4 liter inline 6 will fit my 4.0 98 Sport? I'm going to take parts off of the Cherokee before we scrap it. Thanks

Tire size, brakes, wheel size, driveshaft u-joints, steering, suspension etc. Looking down the road about 5 years for the ultimate set-up if it exists Something for highway, rocks, sand, mud. I don't mind having a couple of different sets of tires. Any and all input is very much appreciated.

Does this look bad? Hatd to tell from the pic but it had a lot of "powder" corrosion on the contacts. Replaced the cap and rotor with Mopar and it seems to idle better. Maybe it's a placebo effect. Time will tell cause I've been getting coded for cylinder 6 misfire and 3 came up also.