Search results

Looking to buy a set of OEM fog light covers for the OBEN fog lights (1997-2004) pictured below. Have tried Ebay but i always seem to be too late. Thanks

Doing a small lift with H&R springs. If additional bump stop is needed, is the preferred way to drill & tap through the 3/8" steel disc and the bump stop pad on the spring perch?

Flag nut broke while removing OEM front track bar. I tried to get a 15mm wrench in from the drivers side but couldn't get it to bite - bolt & nut kept spinning. I am replacing the track bar with an OEM equivalent (Moog DS1235) so ended up cutting through the old rubber bushing, bolt sleeve, and...

You can do it...luckily i had some helpers.

Heated Back Light (rear window defogger) for hardtops.

@MikekiM - If it helps, i picked up switched 12v power from the HBL Relay location in the PDC.

I saved this post from @HoosierRich when i was researching stereo upgrade options because i thought it was well done. He explains mounting the amp under the steering column and has some good pictures, perhaps it will help with your install...

@mrblaine helped me with this recently, possibly for the park release solenoid. https://wranglertjforum.com/threads/anyone-know-what-this-is-for.50879/

I don't run a hard top, so I picked up switched 12v power from the HBL relay location in the PDC.

Followed Jerry's suggestions on a 5lb extinguisher and mount. @Jerry Bransford thanks for the tips and good info about this.

@mrblaine thank you, very helpful and much appreciated.

Found these connectors under the dash to the right of the steering column while upgrading the stereo this weekend, curious if anyone knows what they're for...2004 manual.

With quick disconnect links you can disconnect your front sway bar while off-road, allowing more axle articulation. You'd retain the factory sway bar.

I am currently in the process of rebuilding the front end on my '04. I initially considered a package like this, however, in my situation the hub assemblies and ball joints did not need replacing. I purchased the parts individually and chose to do the ZJ Tie Rod upgrade that @CodaMan mentioned...

Just adding to the randomness of new Moog parts arriving painted vs non-painted. Moog Rear track bar delivered today is painted black 🤷‍♂️

Good to know! They have held up remarkably well i'd say, thanks for posting that picture.

I recently ordered all the Moog parts in the ZJ Tie Rod Conversion thread from Amazon. All parts arrived quickly, the only things painted were the adjusting sleeves. The new Moog track bar was bare as well.

If your new spare wheel is the same 5 x 4 1/2" bolt pattern, the spare will bolt right up to the spare tire bracket. However, with a 3.75" backspace, the spare tire won't make contact the rubber snubbers. I recently changed my factory spare wheel to a wheel with 3.62" backspacing, and had just...

Here's what mine looked like when replacing the axle u-joints recently. An old piece of hose that fit into the tubes connected to the shop vac took care of anything in there. Just be careful so as to not push anything into the diff or damage the seals.