Search results

Thoughts? I drove a Sport S with a manual trans and a hard top ($39K) for the first time yesterday. Nice, but it seems like a lot of money for what you get.

20-lularoe-legging-fails-that-are-almost-too-bad-to-believe I have to believe they were made like this on purpose.

world-us-canada-50511783 I still have one of the originals from 1979- this is my 40th year riding. I meet him a few times in the past, and for a man who's name was plastered everywhere in the industry, he was exceptionally humble.

https://www.cnn.com/2019/11/16/us/flat-earth-conference-conspiracy-theories-scli-intl/index.html Ummm.....wow.

I have these 3 plugs in my engine bay, each coming off of a separate harness. It's an SE, so I assume they are for A/C, cruise and ABS? Since they appear to be capped, could I remove the plugs, insulate the wires and then tuck them inside the harnesses?

'97 2.5, has stalled at least once per drive recently- tach drops to zero, but turning the key while rolling will restart it. Some roughness at cold start with idle wandering all over the place. I have done the following- New MOPAR TPS Aftermarket IAC New Bosch fuel pump less than 500 miles...

https://theblacktux.com/blog/top-beard-styles-by-state/ There are styles I never even heard of.

Should I remove the trans support bolts before, after or not worry about it? I will be using the Eastwood product, and I am concerned that it may gunk up the bolts to the inserts.

I bought these last year ($140 each installed at Discount) but drove less than 100 miles before moving to a larger tire. These still have the blue on the RWL. Asking $300 for all. Pick up only in SE MI.

I found a long console to replace the short version on my SE, and everything bolts up fine except for the two holes on the bottom of the passenger side arm rest portion. There are two holes in the vertical portion near the e-brake lever bracket, so I assume there was some sort of other mounting...

I installed a full set in my TJ a week ago, and the center console portion fit is a joke. There are huge gaps (2-3") around the e-brake, and the front section barely tucks under my short console. I would be happy with just a basic piece that I could lay over the tunnel and cover the gaps, but...

Sold to Leinhit.

Nearly new Cat-back system for 97-99 (slip fit to cat, not flanged), chrome tip, plus upgraded clamps in place of U-clamps. Used on-road for 25 miles- too loud for my co-pilots taste. $100 plus actual shipping costs.

Found one.

I am in the process of replacing my fuel injectors on my 2.5 L TJ. It is a very early build (3/96), so the rail does not have a test port. Will I relieve enough pressure in the system by pulling the fuse until it dies and removing the gas cap to safely pull the rail and fuel line? I am not...