Search results

  1. R

    Wiring Diagram

    Parked the 05 Wrangler X, 135,000 mi, next morning it would turn over fine but no start. CEL Codes were P0108, P0335 and P0340. The research I did steered me to the Cam Position Sensor. I have a three wire system and apparently one wire stays hot coming from the computer, I did have the...
  2. R

    2005 4.0L won't start

    This morning the Jeep would not idle at a stop light and would shut down. Info I found on YouTube for that symptom indicated a faulty Idle Air Control Valve. I picked up a valve and limped on back home having to restart the motor several times . I changed the valve and cleaned the Throttle Body...
  3. R

    Shim adjustments to remove backlash in Dana 35

    Anyone ever make shim adjustments to remove backlash in the drive train YouTube makes it look easy . Any tips would be appreciated. Thank you.
  4. R

    Cracked radiator

    I've got an 05 TJ 4.0L with 135,000 miles. This morning it was cold, I started the TJ to warm it up and left ten minutes later. I had zero heat coming out and about a mile down the road the radiator popped and I've got a two inch rip on top of the radiator near the fill cap. I drove it back home...
  5. R

    Frustrated - Engine Chugging

    I have a 2005 Wrangler X, 4.0L inline six with 125K miles. Suddenly the Jeep will start chugging while driving down the road then shuts down.I have replaced both the Cam and Crank shaft position sensors, two O2 sensors, installed new plugs and the coil pack. Neither of which solved the problem...