ring and pinion

Brand new Ford Dana 44 HP 4.88s. Sold the axle and no longer needed. -High quality parts from either Timkin or Dana in the install kit. -All OEM -Ring and Pinion from Dana/Spicer. -Partial master install kit. -A ton of extra shims. -All Timkin Bearings. -New set of ARB seals. $350

Got some slop in my rear diff. Looking for a stock removal of Dana 35 rear ring and pinion - 3.07's - If anyone has some still laying around.

I’ve finally gotten around to throwing the Dana 44 in that I bought about a month ago. I went to inspect the diff before filling it and I found this piece of the inner most clutch disk on passenger side, sitting in the pocket under the pinion,hiding in leftover fluid. Half of that plate is...

out of the interest of experience, I have a stock dana 30 and 35 with 3.07 gears from a tj laying around, and i found a 2002 liberty with Dana 30 and Dana 35 with 3.73 gearing and Trac Lok. I know swapping a used ring and pinion alone are a PIA, but if i take the ring and carrier with Trac lock out as a...

Yukon Gear & Axle (YG Dana 44-488T-RUB) High Performance Ring & Pinion Gear Set for Jeep TJ Rubicon Dana44 Differential. Yukon Gear & Axle (YK Dana 44-RUBICON) Master Overhaul Kit for Jeep TJ Rubicon Dana 44 Differential . 488 gears. New still in box. Will ship. $350

Yukon Gear & Axle (YG Dana 44-488T-RUB) High Performance Ring & Pinion Gear Set for Jeep TJ Rubicon Dana44 Differential. Yukon Gear & Axle (YK Dana 44-RUBICON) Master Overhaul Kit for Jeep TJ Rubicon Dana 44 Differential . 488 gears. Rear New still in box. $350 For pictures look here...

2004 Jeep LJ Auto 42RLE Dana 30/Dana 44 Have 35s waiting to be put on. I’ve seen recommendations for my setup at 5.38 gears, but the front Dana 30 can only do 5.13. Should i try to find a front rubicon Dana 44 to get the larger size R&P to fit? Plan on building both axles up to support 35s with either choice...

What's the lowest gear you can put in a 35 ? Without changing carrier

Specs: 2001 4.0 Dana 44 Rear Dana 30 Front 32RH Auto Current ratio is 3.73 Research says that the "proper" ratio is 4.10. The question, is it worth the money to swap from 3.73 to 4.10?

This is the stock Dana 44 ring and pinions removed from my 2005 Wrangler TJ Rubicon. They are the factory 4.10 Spicer gears from the front and rear Dana 44 axles. From what I am told, they are 100% interchangeable (meaning the front and the rear are the same), and from looking at them it's...

So, I just picked up my Rubicon this evening from a fellow named Dan with Dan's Gears. He's located in Sherwood, Oregon and has been doing nothing but gears and ring & pinions for the past 35+ years. If you're local to Portland I can't recommend this guy enough. I dropped my rig off on Sunday...

There are a few ways to determine your axle gear ratio: 1. Look for a tag under one of the diff cover bolts in the 9 o'clock position. This will tell you what ratio the Jeep originally had and likely should still have. If someone would have regeared it, chances are they would not put the tag...