steering

Came out my 06 @ approx 70k miles. Was in good working condition when removed. I upgraded to a PSC unit.

Hey guys! I have a situation where I bought my TJ and had the whole death wobble situation so I thought going with a HEIM steering kit would help and it did not if anything made it worse. So I want to go back to OEM but I have a limited amount of money. The HEIM steering kit has 5/8 bolts so I...

Ok while putting the front end back together after doing the u joints and ball joints I went to attach my drag link and the stud was turning with the nut. Soo I needed to replace the drag link.. what I discovered was the PO installed a beefier one than stock and that meant I needed a new...

I recently noticed when backing out of my driveway a little resistance with a grinding noise when turning the wheel. I’ve identified the best I can that it’s not coming from the engine bay. The sound is coming from the steering column. If straight ahead the wheel is at 12:00 on a dial, the...

I bought the "Cure" for my stock steering and never installed it. I replaced my stock tie rod and drag link with Currie items. It cost me $19 plus $9.50 shipping. Will ship to you in CONUS for $14. Contact through this website please. https://www.ruffstuffspecialties.com/catalog/merchant.mvc?

When i bought my jeep it would pull left and right constantly and with great gusto. I swapped out the track bar and then i put on Currie Correctlync steering. i have also now put on Currie control arms. every step of the way has reduced the amount of pulling a great deal and significantly...

Hello all, New to the forum, new to TJ's, made the switch from a long-term relationship with XJ's and finally decided it was time. I found this jeep and immediately called on it and ended up bringing it home. So a few things that I have to deal with are: Tcase drop and no SYE Dana 30 LP...

Happy holidays all! While I was headed to my cousins last night I hit a pot hole and experienced my first death wobble... holy crap was that scary! I pulled off the road to check it all out really quick and that’s when I got my first Christmas surprise lol. The track bar snapped! I have a...

For a long time now (1+ years), my steering wheel makes a squeaking noise when it's cold. The sound is from inside the car, not outside. It happens less when it's warmer. I haven't really tried to debug where it is yet, but I thought I'd ping here in case someone knows the answer already...

After searching online for a definitive answer on dropped pitman arms with the Currie Currectlync I’m more confused than when I started. I know that the track bar and drag link should be parallel to get rid of bumpsteer but with my current set up I don’t get any bumpsteer at all. Unfortunately...

So I’m sure there’s forums on here about this but oh well. My problem is that when I’m driving around 45 or 50 and lightly turn the wheel, the steering wheel wobbles. It also does it while I brake from about that speed. Any ideas on what this may be? I just installed new shocks and got an...

So recently, my Jeep has been riding really rough. I have had other people in the car say that it feels fine so my thoughts is something is a little off in the steering shaft. I read that you can replace the steering shaft bushing and that helps but I am wondering what else could be going wrong...

I have an 05 Rubicon TJ that has a clunk feeling in the steering. I have narrowed the culprit to the slip joint on the upper steering shaft located at the fire wall. My question, can I drill and tap a set screw in the slip joint, or is this joint meant to be telescopic to make up for movements...

I just bought a 97 TJ 4.0L 5 speed. It has a 2.5" skyjacker lift, 33"s and J&J heavy duty steering stabilizer, all done by the previous owner. When driving around, there is a pretty big dead spot in the steering from approximately 10:30pm to 1pm, which results in a lot of wandering on the...

I got my ZJ tie rod in, very happy with it. Is this backwards? Does it matter which side the zj adjusting sleeve is at? Thanks!

Just purchase a 2006 TJ with 101K miles. Runs well but at these speeds the steering wheel shakes badly. Had the dealer replace Tie rod, Drag Link, Steering Shock. Ball joints are tight or at least not needed at this time I believe. Am I looking at the right components or is it more...

New ro the forum. First of all hi and glad to be here. I built a 2002 tj wrangler X turned out great, swapped out the stock power steering for a durango power steering box and now when crawling aired down in low gear the power steering is almost completely lost, anyone else experience this? Tha...

I have an 01 Jeep Wrangler sport(manual). It is on 35's and has a 4 in lift. Every time I shift it throws the jeep to the right really hard. Also it shakes VERY bad and you are never able to keep it straight. It is very hard to control the steering and is getting scary to drive. Another thing...

As there seems to be a lot of Jeep owners out there considering this swap and because we have done the swap ourselves we decided to provide our readers with an article on the subject. In this article we are not going to provide you with step by step instructions on how to swap your TJ steering...

My 2003 TJ SE with the 2.4L motor and Mercedes ZF steering gear has had a leaking steering gear input seal for months. I finally found this post http://www.rubiconownersforum.com/forums/25-rubicon-tips-techniques-write-ups/61757-steering-box-input-seal-replacement.html that walks one through the...