sye custom rear drive shaft

I am in the process of the 8.8 swap, as well as JB conversions super short sye in the T case. My question was, should I use the output flange or the output Yoke on the transfer case? I have both the flange and yoke, but not sure which is better to use.

Per previous post, I've spent the last two months chasing a shimmy. Some say it's vibrations, some say shimmy. With everything I've done and replaced, I'm at a point where removing the rear driveshaft or putting it in 4H eliminates the vibrations. Some suggest SYE and new driveshaft but that...

Hi All, Has anyone used a TJ Rubicon Rear Driveshaft and added a Center Yoke to work with a SYE setup? It would appear to be a cheaper setup than buying a new CV Rear Driveshaft but I would hate to go to the trouble if it will end poorly.

I have a 3.5 suspension lift and 1.5 body lift. I think I need an Slip Yoke ELiminator to get that drive shaft angle down. I also would like to bolt my heavy duty transfer case rock protector flush with the frame. Questions I have: What is the recommended best SYE? Can I order the right...