vibrations

Per previous post, I've spent the last two months chasing a shimmy. Some say it's vibrations, some say shimmy. With everything I've done and replaced, I'm at a point where removing the rear driveshaft or putting it in 4H eliminates the vibrations. Some suggest SYE and new driveshaft but that...

I bought my first Jeep, 1999 Wrangler, a couple of months back. It has a 3" lift with 33" Mickey Thompson Baja's. On its first highway drive, it vibrated a lot. Vibrations were felt through the steering wheel and seat. I heard jeeps ride rough. I have nothing to compare it to, so I figured...

Hello all! I've had my TJ for about a year now, it is a 2004 wrangler X and its been quite the adventure. For the entire year i've had speed sensitive vibrations that I have tried to get rid of. The past year I have removed the front driveshaft due to damage on the body and replaced the rear...

Hey friends! Hope all are well out there! My 2000 Wrangler sport got fitted with a 2.5 inch lift kit with Fox shocks. I bought adjustable rear upper and lower control arms, in addition to adjustable front and rear track bars hoping that I wouldn't get vibrations. The vibrations persisted and...

Hey Everyone, I’m new to this forum but have had my 2001 Jeep Wrangler Sport since it was 1 year old. I finally had enough extra cash to put a 4” lift on it with my dream wheels and tires (20” Fuel Assault w/33” Patagonia Milestar M/T. I got it back yesterday but the alignment is so bad the...

Hello, Two months ago I installed a 4.5 inch lift from Rubicon Express (I also have a 1.25in BL) in my Rubicon 06, the SYE was not needed because its a Rubi, but regarding the driveshaft..... my neighbor have a shop and he usually makes the driveshafts (or repair them) for big trucks, semis and...

Installed AA SYE and TW CV shaft along with a Barnes 4WD bolt on skid plate with their transmission mount. I’m chasing some mild vibes that start at 70mph and I’ve noticed that my Tcase is very close to my skid plate. Maybe an 1/8” or 1/4” max between the bottom of the case and the skid. Doesn’t...

After found a big crack in the exhaust manifold (4.0L 1998) I decided to upgrade the exhaust line with: Replacing the manifold with a new one, with flexible joints; New bolts set & Fel-Pro gasket Wrapping the manifold with a really good quality Aeroflow exhaust wrap to reduce heat up to 70%...

I have a 2002 Jeep Wrangler that has a Pro Comp 2 inch lift with 32 in tires. Ever since the lift and tires there has been a vibration, mainly from my seat and center console, that starts at 50mph and gets worse and worse as I go faster to the point where the vibrations shake the mirrors where I...

Been a while since I have logged on but I'm getting some slight vibrations and a little shimmy around 50 mph. I did have death wobble a few months back but I got that fixed! But now I have a slight vibration with a shimmy around 50 mph I also done my front and rear brakes when I was fixing my...

I daily a 2006 “Golden Eagle” TJ that has had terrible vibrations throughout the vehicle. The dash, wheel, shifter, everything has been violently vibrating for the past few days. I put on smaller tires for a few days (31” down to 30”) on the back for burnouts and drifts and whatnot and thought...

Notes: 97 TJ Everything adjustable (8 control arms, front track bar, even sway bars) 4" lift Transfer Case drop installed. New tires with less than 1000km on them. Balanced with beads. I've had all the tires balanced and had a full alignment done. I was in the shop when the alignment was all...

I'm hearing vibes at around 45-55 mph (actually higher, I found out today that I'm indicating about 12% off, but ignore that, I'll get that fixed), but the vibes only happen in 4th gear. (4 speed auto). I've been getting around this by switching the O/D off until I'm at 60, but obviously...

Hey everyone, so I recently got a lift put on, the 4.25 zone combo lift, and discovered after it was put on, there were some noticeable vibrations for about 10 seconds on acceleration then they go away. I thought at first it was because my alignment was all messed up but even after getting that...

I recently put a 2” puck spring lift on my tj. Ever since I got a vibration during acceleration. I ordered a 1” body lift and 1” mml hoping to corrrct this. Will this work? Any suggestions? Thanks

Okay guys here goes. I have been dealing with a vibration problem for the last 8 months and it’s driving me insane. I have a 2000 wrangler tj with modifications. I run a rear 8.8 and a 44 in the front. I have a 4” lift. The vibration seemed to start when I removed the old Tc drop that was...

So I have an '05 Tj 4.0 6speed man. Every once in a while I have a vibration when stopping. Sounds like its coming from transfer case area. A friend says theres a needle grease fitting on the front of the transfer case. I can't find it, anybody here know what he's talking about? I found...

I have a 97 Wrangler, 4.0, 5 speed, four inch lift with adjustable everything, SYE with an Adams CV driveshaft. Got the pinion angle dialed in, it has the very slightest vibration at 25-30mph, so small that others don't even notice it. At right around 60 and up I get a droning vibration, after...

Good morning and thanks for your help in advance. I just bought my first 97 Jeep Wrangler tj, and im hearing a noise under the jeep when im driving. The faster i go the louder it gets. When i let off the gas it stops. SO this morning im going into the difs to inspect and change the dif oil...

Ya I know! No pictures didn't happen. I had Stinger aligned and the shop found a problem with the thrust angle. Then they realized I had adjustable control arms on the rear. So-— they attempted to adjust the angle and found one of the gyro joints frozen. So they did all of the adjustment from...