So my 03 just started sloppy shifting from 3–4.
it gets hung up, and revs slightly higher before getting it into 4th.
I recently changed out the TPS as I was getting g the voltage too high p0123, and upon pulling the tps I noticed the old sensor was a little crunchy. the replacement is a Mopar TPS and that issue is gone now.
it really only does it when casually driving and not when I am into the accelerator hard. Under hard acceleration it shift normally. It also shifts normally with OD off
my fluid level is good and the fluid is clean and clear, no real burnt smell I can notice.
the trans has 135k on it. Am I in for a rebuild soon? PCM still mapping with the new sensor? I just changed the sensor about 2 weeks ago I have drive. It less than 150 miles.
decent shops in Greeley/ft Collins areas?
i understand the 42rle is electronically monitors and will tell me when it’s not well, no codes to be read at all.
it gets hung up, and revs slightly higher before getting it into 4th.
I recently changed out the TPS as I was getting g the voltage too high p0123, and upon pulling the tps I noticed the old sensor was a little crunchy. the replacement is a Mopar TPS and that issue is gone now.
it really only does it when casually driving and not when I am into the accelerator hard. Under hard acceleration it shift normally. It also shifts normally with OD off
my fluid level is good and the fluid is clean and clear, no real burnt smell I can notice.
the trans has 135k on it. Am I in for a rebuild soon? PCM still mapping with the new sensor? I just changed the sensor about 2 weeks ago I have drive. It less than 150 miles.
decent shops in Greeley/ft Collins areas?
i understand the 42rle is electronically monitors and will tell me when it’s not well, no codes to be read at all.