Noticed the blower motor cutting off for a few minutes and back on again. Did this several times then finally off for good.
the fuse was ok
the relay was ok
tried a new resistor (not it)
took the blower motor out and ran 12volts to it (it's fine)
replaced the fan speed switch
replaced the Heater/AC vacuum switch
....still nothing
there is a connection between the heater/ac vacuum switch to the fan speed switch via the wiring harness. My question is, is there any reason to replace the ac control panel if I've already put new switches on it? I also noticed that only 1 of the 3 LED's come on on the panel (doubt that means anything)
thanks for any help
the fuse was ok
the relay was ok
tried a new resistor (not it)
took the blower motor out and ran 12volts to it (it's fine)
replaced the fan speed switch
replaced the Heater/AC vacuum switch
....still nothing
there is a connection between the heater/ac vacuum switch to the fan speed switch via the wiring harness. My question is, is there any reason to replace the ac control panel if I've already put new switches on it? I also noticed that only 1 of the 3 LED's come on on the panel (doubt that means anything)
thanks for any help