Any idea where this electrical connector goes near transmission?

Boomer453

TJ Enthusiast
Joined
Jan 5, 2020
Messages
133
Location
Louisiana
Finishing up re-installation of my transmission and have one electrical connector that for the life of me I can't figure out where it goes. It splits off the wire harness just about where the bell housing meets the transmission. Looks like this. Please point this fool in the right direction
20201121_164105.jpg
 
My jeep has a 4.0 engine and 42RLE auto transmission. The only connectors I can think of in that area are O2 sensor, range sensor (4WD switch), input speed sensor, output speed sensor, pressure switch solenoid, or crank position sensor.
 
I should have said this is an 06 6 speed 4.0
The one at the very rear of the transfer case is connected. The CPS is connected. The one next to or behind the 4wd linkage is connected.
This is the last one to connect.
 
I didn't check before posting the link but now that I have, it looks like that's for the backup lamp switch for the M/T.