Anyone have a set of control arm bolts they would be willing to part with?

[TJ's-TJ]

We have a good set of the frame side bolts for all (8) control arms (as the control arms were cut and the top halves were still with the frame). However, the control arm bolts in our crusty axles were not re-usable. Anyone happen to have a usable set that they would part with?

Need front and rear, upper and lower, axle side only, so 8 bolts total...

Probably a long shot, but figured it was worth asking before starting to scour the internet for a set...


Thanks!

 

[derekmac]

I had to replace a couple of control arm bolts, and I think I just used grade 8 9/16 bolts.

 

[fuse]

For the uppers, you want zinc-plated, class 10.9, M10 x 1.5mm x 80mm with prevailing torque nuts.
For the lowers, you want zinc-plated, class 10.9, M14 x 2.0mm x 105mm bolts with standard nuts.

Check out boltdepot.com. They'll have the right size for the uppers, but you might have to get a longer bolt for the lowers. It will probably cost you a couple bucks a bolt, and you'll probably pay about as much in shipping. But in total it will only be a few bucks. Definitely much cheaper than OEM bolts, but still the correct spec.