Okay I am completely stumped. So I was driving fine and it suddenly went into limp mode and I barely got home. Shut it off and no start ever since. Only codes I'm getting is p0032 and p0038. Bank 1 of both sensors the heater control circuit is running high. Obviously that doesn't make any sense at all since I'm fairly certain both O2 sensors did not have issues simultaneously. So obviously I've got a wiring issue and I cannot find it to save my life.
I have checked the sensors which appear to be okay however there is a scuff mark on the tip of the camshaft sensor. I also am getting fuel I am getting a spark but if I put gas right into the throttle body I still don't start. I've also checked all the relays and they are fine.
I hate to admit that I am not very familiar with using a voltage reader so I can buy that and teach myself how to use it. But I figured I would at least throw it out here first and see if anybody has any ideas. 4 years ago the only thing I could do was check my oil, so I'm getting there LOL!
I have checked the sensors which appear to be okay however there is a scuff mark on the tip of the camshaft sensor. I also am getting fuel I am getting a spark but if I put gas right into the throttle body I still don't start. I've also checked all the relays and they are fine.
I hate to admit that I am not very familiar with using a voltage reader so I can buy that and teach myself how to use it. But I figured I would at least throw it out here first and see if anybody has any ideas. 4 years ago the only thing I could do was check my oil, so I'm getting there LOL!