WTB: I need a rear exhaust hanger
- Thread starter ogre
- Start date
- Status
is the riser on the trans mount still in use?
if i remember right there are 2 more hangers but those are part of the pipes and you just need the rubbers to hang them. if the pegs are gone off the frame rail well then you gotta improvise.
if i remember right there are 2 more hangers but those are part of the pipes and you just need the rubbers to hang them. if the pegs are gone off the frame rail well then you gotta improvise.
There are two mounts after the cat.
The first inline was still there with the isolator so I able to use it.
The rearmost hanger has been removed from the passenger side frame rail.
It bolts to the frame, so if I can find one, bolting it in shouldn't be too hard to do.
Without a hanger there the tailpipe will end up cracking or loosening up I would think
The first inline was still there with the isolator so I able to use it.
The rearmost hanger has been removed from the passenger side frame rail.
It bolts to the frame, so if I can find one, bolting it in shouldn't be too hard to do.
Without a hanger there the tailpipe will end up cracking or loosening up I would think
i have a rear frame section out back. after work i'll take a peek and see if the pegs salvageable.
I'd honestly rather give my money to anyone before the local yards.
There are a couple I could stomach, but they are 2 or hours away.
I guess I could ask one of them if they could ship, but figured if someone from this board had one I'd prefer to do that.
There are a couple I could stomach, but they are 2 or hours away.
I guess I could ask one of them if they could ship, but figured if someone from this board had one I'd prefer to do that.
LONGJP2
TJ Expert
I've already planned how to build one if I have to.
Plate with two holes drilled that match the frame mounts.
One of those or similar rod welded to it with a isolator connecting it to the exhaust.
Doesn't look like it would be too hard to replicate the function of the factory mount but without a welder here, I would need to beg a friend to use his.
I'm planning on grabbing some parts from one of the local self service yards, (no wranglers in the metro Atlanta area that I've found) and I'll be looking for anything similar that I might be able to modify with what I have available here.
Plate with two holes drilled that match the frame mounts.
One of those or similar rod welded to it with a isolator connecting it to the exhaust.
Doesn't look like it would be too hard to replicate the function of the factory mount but without a welder here, I would need to beg a friend to use his.
I'm planning on grabbing some parts from one of the local self service yards, (no wranglers in the metro Atlanta area that I've found) and I'll be looking for anything similar that I might be able to modify with what I have available here.
- Status