Hello all, I recently put some round maxbilt led lights on my Jeep. I cut the end off of the old tail lights with the connector and used that to hook my lights up.
They worked fine no problems but I need license plate lights. I bought the screws with LEDs on the ends and so I have 2 sets of cables 4 in total two positive two negative.
What is the best method to hook these up to the tail lights? Should I use vampire splicers on the screws and then use a 2nd vampire splicer to hook up the screws to the tail light or one vampire splicer for each screw individually into the tail light? Thoughts? ideas?
They worked fine no problems but I need license plate lights. I bought the screws with LEDs on the ends and so I have 2 sets of cables 4 in total two positive two negative.
What is the best method to hook these up to the tail lights? Should I use vampire splicers on the screws and then use a 2nd vampire splicer to hook up the screws to the tail light or one vampire splicer for each screw individually into the tail light? Thoughts? ideas?