My new top

[Blair]

This is my new top. Got tired of getting fried every summer so got this to cut down on the UV and the heat. My wife loves it for shopping for ease of parking. This top is bullet proof and totally transparent.

 

[AOR]

 

[Chris]

Very, very cool! Didn't even know this existed until now!

 

[wheelhead]

Do you have a link to where you got it.

 

[Chris]

Do you have a link to where you got it.

Check out the link in his signature, http://jeeplid.com. @Blair is now a forum sponsor.

 

[wheelhead]

Check out the link in his signature, http://jeeplid.com. @Blair is now a forum sponsor.

Thanks didn't see that.

 

[Shelly]

What kind of back windows would you need to use this with?

 

[Chris]

What kind of back windows would you need to use this with?

I'm pretty sure he has two versions, one with side windows. I don't want to say for sure, but I'll wait until @Blair chimes in.

 

[John M Beard]

Interesting, very, very interesting...

 

[Shelly]

I saw on the website. You can buy the lid, rear windows and back window for $800

 

[VirtualRussel]

This is my new top. Got tired of getting fried every summer so got this to cut down on the UV and the heat. My wife loves it for shopping for ease of parking. This top is bullet proof and totally transparent.

I've seen your product online before and was instantly blown away. Is there any chance you have an LJ version in the development pipeline?

 

[Blair]

I saw on the website. You can buy the lid, rear windows and back window for $800

check out the videos on https://www.facebook.com/jeeplid and look for the falling cinder block!

 

[Chris]

View attachment 3615

check out the videos on Facebook.com/jeeplid; look for the falling cinder block!

Is there an LJ model Blair? @VirtualRussel was curious.

 

[mouth]

I seen a posting on FB , a big question was about the LJ version and how the mold/ tooling? And it Was a insane amount of $$$. Not sure there will be ehough LJ buyers to justify cost. Again just repeating what I read.

 

[Blair]

Is there an LJ model Blair? @VirtualRussel was curious.

The number of LJ models produced are not enough to justify the cost of the tooling. Between the initial laser scanning, the solid
modeling work and the changes the tooling manufacturer does to compensate for cooling shrinkage, and then the actual tooling
cost to produce a heated aluminum mold, it would be insane to do the tooling for such a small sampling from the jeep line up.

 

[Blair]

I'm pretty sure he has two versions, one with side windows. I don't want to say for sure, but I'll wait until @Blair chimes in.

We furnish two different side kits. Looking at them, you can't tell any difference, but one is for jeeps with soft tops, and the other is
for jeeps with the hard top. There is a small gap at the top which never bother us this winter; we just turned the heater on.