Hey Guys,
I got my rear 12" Fox RR shocks installed without issue last weekend but am a bit stumped with with one of the steps for the front.
I have removed the factory shock mounts and have the lower mount tacked in place (with a best guess starting point). I have a dummy shock setup at the length of 1/2 travel and am using that to attempt to place the poly tower in its approximate location so I can mark the cuts needed to blend it into the frame (like I did for the rears). This is where I am a struggling a bit... Does anyone have some tips for getting the poly towers marked close so I can cut them and then grind the cuts to tweak the location? the frame is a bit complicated right where the poly tower needs to live and I am hoping some of the more experienced fabricators have some pointers.
I am currently attempting to cardboard CAD pieces to show me my cuts on the towers... and it is a struggle
I got my rear 12" Fox RR shocks installed without issue last weekend but am a bit stumped with with one of the steps for the front.
I have removed the factory shock mounts and have the lower mount tacked in place (with a best guess starting point). I have a dummy shock setup at the length of 1/2 travel and am using that to attempt to place the poly tower in its approximate location so I can mark the cuts needed to blend it into the frame (like I did for the rears). This is where I am a struggling a bit... Does anyone have some tips for getting the poly towers marked close so I can cut them and then grind the cuts to tweak the location? the frame is a bit complicated right where the poly tower needs to live and I am hoping some of the more experienced fabricators have some pointers.
I am currently attempting to cardboard CAD pieces to show me my cuts on the towers... and it is a struggle