STICKY Share Your 3D Design Files (or Sell a DIY Part)
- Thread starter SSTJ
- Start date
Steveorino
New Member
I've modelled and printed a replacement bushing for the rear seat of a 1997 Jeep Wrangler TJ. I had the plastic bushing on one side of the tub but not the other. The genuine Mopar part is 5103469AA Bushing-Pivot but this could be used as a temporary fix.
https://makerworld.com/en/models/81695#profileId-86986
Hope that it helps someone else!
https://makerworld.com/en/models/81695#profileId-86986
Hope that it helps someone else!
Steveorino
New Member
And now I have done the front seat bushings too. I don't normally have too many passengers so I imagine that these should last a little while for me. If not then I'll print some replacements. There are only using about 4g of filament.
https://makerworld.com/en/models/86225#profileId-92114
https://makerworld.com/en/models/86225#profileId-92114
I have been working on this switch panel for the last couple weeks.
Share a file if you post one, and I'll add it to the list.
Bump. What new parts do we have? I should probably improve the list with pics sometime ...
TJs have no cabin filter. If you are tired of blowing dust in your face then this may be for you: https://www.printables.com/model/562686-jeep-wrangler-tjlj-cabin-air-filter
Do not use PLA, it can't withstand the heat. And honestly this is probably not a good use for 3d printing.
Is there a benefit to printing using the modular pieces as opposed to the first file that is a single piece?
What filter does this utilize?
It takes the same cabin filter as a JK. The inventor created the modular version first and the files are free. He has since upgraded to a single piece version which he sells for $40 on eBay. I'm a cheap mofo so, I'll print the free version. But for those that want to buy the single piece the link is below. He also has a water shield for it, but he says it's not really necessary.
https://www.ebay.com/itm/1159138737...pid=5337789113&customid=&toolid=10001&mkevt=1
https://www.ebay.com/itm/1159898397...pid=5337789113&customid=&toolid=10001&mkevt=1
This site contains affiliate links for which Jeep Wrangler TJ Forum may be compensated.
I'm using PETG, but nylon would be better for those whose printers are capable.