Upper control arm bolt/long arm

[inkedrose]

My upper driver side control arm bolt pulled out. Jacked it up from skid plate and bolt seemed to be moving further into place as it articulated but not comfortable being under it that high with no support. Was going to disconnect the front to get the rear in but it seems like I'll have same problem reconnecting the front? Have adjustable control arms so I could extend them but I'm guessing they were set up proper length initially (lift was on when I got it)? Stumped, any ideas?

I know, "go to short arms/mid arms, long arms suck, blah blah" lol

 

[inkedrose]

Never mind I got it! Used a come along to hold everything in place, undid the front, rebolted back, put front back together... way easier than I expected. Anything else that I should be watching for or may have f#cked up while I was doing this? Pinion angle seems same?