Ctdriver86
Member
Did you have this for sale recently? I could swear I was begging my wife to let me buy it, not too long ago.
What did you do to your TJ today?
- Thread starter LJRubiconGuy
- Start date
Did you have this for sale recently? I could swear I was begging my wife to let me buy it, not too long ago.
Fun day for a Monday ....
Fixed my 02 (2096) code - new NGK02 sensor and tightened the pre cats -
Then loaned trailer to Dave to move some stuff and took it to a friends shop for a tailgate install- this trailer needs it bad
Washed the LJ
Then drove it to meet a client and got it dirty
Now half door fine tuning -
Also polished my TJR factory windows yesterday - not had for 20 years old
Sending Dave home in the TJR so he can pull his transmission harness to detail it -
Fixed my 02 (2096) code - new NGK02 sensor and tightened the pre cats -
Then loaned trailer to Dave to move some stuff and took it to a friends shop for a tailgate install- this trailer needs it bad
Washed the LJ
Then drove it to meet a client and got it dirty
Now half door fine tuning -
Also polished my TJR factory windows yesterday - not had for 20 years old
Sending Dave home in the TJR so he can pull his transmission harness to detail it -
Last edited:
I just bought it in Arlington,TX on Saturday it was a freaking terrible drive I will never go back to that part of Texas again
Ctdriver86
Member
Pics when your done… I did old AR aluminum wheels a couple months ago… does the ceramic coating work well on the aluminum? Asking because ceramic coating is new to me.
Finally getting around to pulling out the old caved in grille that the PO demolished. Got a new one going on that I did black bed liner on. After that, the driver's side fender needs some attention to get the damage all repaired.
My system was flat when I took custody in 21. Topped it off with part of a can and it blew snowballs.
About a year later it wasn't all that cold. The same can had enough to top it off again, and its been perfect since. Top of the green is where I ended up as well.
Blows high 40s out the center vents with 110+ ambient
Did you buy the grill overlay or did it come on your TJ? My grill is trashed from the PO installing those silly inserts into the grill slots. I don't want to paint it.. can't undo that. The matte overlay would be perfect, but they are impossible to find.
That looks awesome. I have all the tools and materials to do a deep paint detail but zero time or energy. My paint is pretty good but the body doesn't match the still pristine half doors I refinished this past winter. Can't tell when it's dirty, but when it's clean it is obvious the doors were redone.
I do them twice a year.. this is what they look like when I'm done.
Just drove by to check on it. My ruptured disc is still too painful for me to replace the crankshaft position sensor. UVA Pain clinic can't see me until 11/8. 
MD.PipeGuy
New Member
I found a Mopar chrome grille overlay at Baseline boneyard and had it wrapped in 3M satin black. I may take that off and have the grille wrapped instead.
Replaced the driver's seat cushion bottom, installed Diver Down seat covers, and installed rear seat shoulder belts (they were just lap belts before). Special thanks to hosejockey61 for the seat cushion how-to video, it was so easy to follow!
Installed the Mopar yesterday & ordered another ebay cable as a spare. side by side, the cable looks the same but plastic sheeth and nipples are sturdier on the Mopar
I noticed some of the black plastic wire protectors are brittle or close enough to fall about when inspecting them around the jeep. I have been going over and replacing where needed. In the hot spots, specially near the exhaust I found this online, ordered 1/4",3/8",1/2" x 4ft. I dont believe it was more than about $40 total.
Yup... Been looking for a chrome grill overlay as well. Figured that would be an easy DIY to wrap. I would have figured they would be as easy to find as bumper milk jugs. Not around here. Even with all the angry bird grills, no one has the overlay. If you choose to take yours off and want to off-load it, let me know. I looked into a wrap on my grill but those F'ng grill inserts wrecked the paint so bad it would show through the wrap.
We don't have any of those pick-n-pay salvage yards around here either.. I think that's what you guys call them
Finished the grille except for the trim rings, going with black instead of the chrome ones.
Ladybug's (grand children name) four month anniversary today. As a show of affection replaced the wind shield wipers with Bosch ICON.