Here are my angle measurements on the transfer case and pinion. I checked it with a cell phone app. The driveshaft is 20.2 degrees. So people can check my math. I measured each control arm to make sure the axle is square. Joints are two days old. No impact on the drive shaft so I cant see it being out of balance. I can't figure this out. I thought I had both angle finders on the same zero, but the difference is basically zero.
View attachment 395899
View attachment 395900
View attachment 395904
View attachment 395901
View attachment 395902
View attachment 395907
Did you have the driveline balance checked?