That's where i put all my stickers too!Got to add another sticker on the tail gate too. Each shock came with one. View attachment 147629
Last edited:
That's where i put all my stickers too!Got to add another sticker on the tail gate too. Each shock came with one. View attachment 147629
LOL I didn't realize my old ones were shot. If I'm correct they are supposed to come back out once compressed, right? LOL
View attachment 147626
Hey, I got the Brown Dog MMs and didn't get that sticker. I've been shorted. LOL
too late, they're already purple..I would send them back defective!
too late, they're already purple..
that alone deserves a sticker!I did mask off the American flag though!
Out here your cant tint your front windscreen at all....only a small strip across the top no deeper than your sun visors) and that's it..Got the tint knocked out and replaced all the brakes on one of my YJ’s.
5% all the way around with 50% on the windshield.
Haters rejoice, but it was mainly for my light sensitive eyes.
View attachment 147493View attachment 147494View attachment 147495
Thats what I did when I got a set of original half doors. I just painted them myself. I'm very happy with the resultsPicked up some factory half doors today. Wrong color red but they're factory.
Repaint the outside and inside, new mirrors, and I'll be good to go. View attachment 147735View attachment 147736
HP30 is a great, low cost, upgrade to the TJ!Jumped into the SYE install. Overall pretty easy, except I can't seem to figure out how to get the C clips on without destroying them thought about drilling a couple holes in them like normal snap rings have, so the pliers have better control. Either they pop out of the pliers and go flying across the driveway, or they deform and are ruined, so far.
The tcase chain is super loose and making contact with stuff other than the gears, so waiting on a new one to come in the mail.
Also found a high pinion Dana 30 front for a good price (to replace my bent low pinion). Would have to regear it and I think I might need adjustable control arms to make it work (and a driveshaft?). On the fence but this seems like a good time to get it done depending on how much additional $ it's gonna eat up to make it work. What I like about the low pinion is that even with the axle seal blown there's probably still oil lubricating the pinion. Just can't seem to find one for a reasonable price
View attachment 147916
View attachment 147917
Also found a high pinion Dana 30 front for a good price (to replace my bent low pinion). Would have to regear it and I think I might need adjustable control arms to make it work (and a driveshaft?). On the fence but this seems like a good time to get it done depending on how much additional $ it's gonna eat up to make it work. What I like about the low pinion is that even with the axle seal blown there's probably still oil lubricating the pinion. Just can't seem to find one for a reasonable price
That's good to hear. I was worried the cost savings over a brand new housing/axle might be moot I had to get a new front axle, control arms, ring/pinion.My driveshaft worked perfectly with the HPD30 swap, no changes needed.
That's good to hear. I was worried the cost savings over a brand new housing/axle might be moot I had to get a new front axle, control arms, ring/pinion.
Good find on the half doors!Picked up some factory half doors today. Wrong color red but they're factory.
Repaint the outside and inside, new mirrors, and I'll be good to go. View attachment 147735View attachment 147736
Good job on the half doors, they look great!Thats what I did when I got a set of original half doors. I just painted them myself. I'm very happy with the results
View attachment 147914
View attachment 147915