Okay, I’m an idiot. These ARE, in fact, custom instructions. I was just reading through the service manual to figure out where the ignition coil is and get my bearings before I attempt install tomorrow, and the diagram on the instructions included with the kit is straight from the service manual. Derp.
Anyway, my plan is to run the wire through the plug above the pedal. I’ll drill a tiny hole to pass it through to the engine bay and get it to the coil. Going to splice the red wire with the kill switch wire using the included crimp connectors. I found an awesome spot to mount the switch today; will post a pic tomorrow. I think I’ve got this under control after all! Haha. My only concern now is figuring out how to make sure the wire is properly secured within the bay.
Anyway, my plan is to run the wire through the plug above the pedal. I’ll drill a tiny hole to pass it through to the engine bay and get it to the coil. Going to splice the red wire with the kill switch wire using the included crimp connectors. I found an awesome spot to mount the switch today; will post a pic tomorrow. I think I’ve got this under control after all! Haha. My only concern now is figuring out how to make sure the wire is properly secured within the bay.