AndyA
2006 TJ X From Tucson, AZ
Latest activity Postings About
-
-
AndyA replied to the thread Wranglerfix PCM versus the others.Here is a recent post I made regarding my Wranglerfix PCM: https://wranglertjforum.com/threads/o2-sensor-voltage.91438 Andy -
AndyA replied to the thread O2 Sensor Voltage.I've been doing a bit of driving with my old PCM and it is so smooth on the idle and acceleration! Much nicer. So far no shuddering and...
-
AndyA replied to the thread O2 Sensor Voltage.NGK - NAPA Andy
-
AndyA replied to the thread O2 Sensor Voltage.Timeline: July 5th 2023 - replaced the PCM January 17th 2024 - replaced all four O2 sensors due to P0133 January 4th 2026 - replaced...
-
AndyA replied to the thread O2 Sensor Voltage.It is a Wranglerfix PCM. I might put my old one back in to compare. Andy
-
AndyA replied to the thread O2 Sensor Voltage.I think the problem I have is transient - bank one goes into a strange state then back out of it again. Lots of misfires.
-
AndyA replied to the thread O2 Sensor Voltage.With ignition on and fully warm, sensor 1/1 is toggling between 0.1V and 0.88V. 2/1 is toggling between 0.1V and 0.8V. However 1/2 is...
-
AndyA replied to the thread O2 Sensor Voltage.With ignition on, the voltage on the K41 PCM pin is 3.3V and drops over about a minute to 2.2V. Andy
-
For the last few years I have been fighting constant problems with B1S1 O2 sensor. P0133. I replaced all four O2 sensors with new NTK...
-
AndyA replied to the thread Front stablizer bar - correctly installed?.Thanks. I just checked and they are still torqued to 45 ft-lbs per the FSM so this must be how I installed them. Do I go higher on the...
-
I installed the front stabilizer bar a couple of years ago, following the FSM and torquing it as required. Now that I look at it...
-
-
As soon as I plugged in the OBDII reader to look at live data the engine started behaving. I told ChatGPT and this was its response...
-
-
Those bump stops look longer than stock. With the sag on your springs (it appears you have 1 in of front spring sag) it has the bump...
-
That looks like a lot of bump stop. At ride height how much distance do you have for up travel before the bump stop bottoms out vs how...
-
AndyA replied to the thread Shuddering over every bump.So you don't think this is a stock bump stop? How long is the stock version? Andy
-
-
Loading…
-
Loading…
