You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
-
-
Good eye, that is one of my other toys: 1966 Volvo 122S Amazon with a LS1 5.7 swap from a Camaro
-
RockJock CE-9110RK 2.5 in. Johnny Joint Rebuild Kit
This fits perfectly. I didn't need new balls but maybe this is just because they...
-
I got some in from trail-gear because they stated the barrel dimension were similar but the races are much to wide in diameter to fit...
-
RockJock says the CE-9110RK fits in a barrel of 2.188: and mine is 2.11" That is a pretty big difference with something that doesn't...
-
I am having the same issue, were you ever able to get this resolved?
-
I will check but with 33" tires and the PCM reading correctly I assume there is a corrected sensor in there or somewhere!
What you are...
-
everything has been modified but I have not done any of these mods so IDK.
BUT what would need to be modified if the PCM is showing the...
-
I measured and the balls seem to symmetrical from center.
They are pretty pitted up, here is a better picture:
-
There is a stamp on the race 9336
-
2005 Wrangler Rubicon.
my speedometer is very wrong (looks like 10mph ish faster than I am going whenever going over 30mph).
BUT I read...
-
I have an unknown suspension on my rig (2005 Wrangler Rubicon).
I was able to replace the drivers side rear upper joint races using the...
-
Loading…
-
Loading…
-
Loading…