Recent content by gasiorv

I got this kit for my son on sale for $169. It is a common item that goes on sale at HF. Pittsburgh tool set It was decent enough that I bought another one for myself to throw on the trailer when I travel.

Enjoying my coffee this morning and and while checking out and enjoying the pics above I looked down and noticed the gnome/wizard combo. I think they are both telling me to go wheel soon. Great pics and happy to see you all out wheeling!

Nice!! Not sure if my words have ever been referred to as wise, but when followed you either have a really good time or I never hear from you again 🤷 Easy Doesn't Make Good Stories, Take the Hard Line!

1up mount works great, it pushes a ball outward against the inner side of the receiver so it really gets tight with no twist or wobble at all. I wouldn't hesitate to use that extender. I have the original 1up single mount and an extra tray. I made my own plate to bolt the extra tray onto so...

Expensive but worth every penny is the 1 up. If you do a lot of riding just bite the bullet and get the 1 up.

Only possible way to check (without pulling shafts) is to open the cover and see if the drivers shaft is touching the pin, if you have a locker that may be difficult. If everything seated and it hasn't started leaking you should be ok

Not saying you did this but I just bring it up because I have seen it happen in the past and it is just good to know. If you swap the shafts by mistake and put the longer shaft in the driver's side, it will start to leak again pretty quickly. The shafts can be installed on the incorrect side...

I am actually in the market for a front Dana 60 and a RJ60 would meet the need if you have one sitting around.

I have had the same experience as Tworley with the lube lockers. If you are planning on being in the rocks, stick with the RTV. If not the lube locker works great.

My dad used to have a topper on his F150 and had a toolbox similar to what you have in the front. I think he had to install the top and then install the tool box so that the tool box was sitting on top of the topper flange (which was sitting on and clamped to the bed flange). I always thought...

Pic of cross brace I added

I added a cross member to that track bar mount, it runs from the track bar mount to the frame on the other side. Of course I am in full support of the stretch, but in the meantime you could just weld that crack and then run a cross member.

I was not in downhill/rock garden shape on this last trip but I did feel pretty good on some of the climbs and got a few PRs on climbing sections. Need to get more practice on the downhills and in the rocks to get back in shape to rail them. I actually just converted my bike back to SS and...

Hot Springs has more rock and less clay compared to Hawk Pride. If it is wet you're jeep will come with much less mud on it than from an Alabama or TN park. It's a little bigger overall compared to Hawk Pride. Hot Springs is a great park and a highly recommend giving it a go.

Few pics from the trail guide Sat morning ride. It was a lot of fun and a great group. Pics are from one of the other trail guides and she takes some great pics!!