Recent content by Jeep R/T

Hanson bumper

I had been thinking the same about the inside of the hardtop, what did you use ?

Almost ready to install my Advanced Adapters transfer case cable linkage to get rid of the corroded , binding mechanical shift linkage.

You do get what you pay for at times , I bought a Snap - On ball joint / u joint press years ago , it came with all kinds of adapters . Years of great service a whole lot of ball joints and u joints pressed in and out with that tool.

My '99 came from Michigan too one owner, I took a Blue Point scaler tool and went over every inch of the frame . It was like shot peening the frame ,it took off stuff that a wire wheel wouldn't even budge this tool did an outstanding job . It does about a quarter size area at a time but it also...

I

'99 TJ - $6700 130,000 mi. 4.0 - 5sp.

Oil pump was easy after I had the tool to properly install the pickup without damage . Then removed the cam gear from an old distributor and slid it back down and hooked up the Milwaukee 1/2" drill and primed the pump up to 75lbs. I hooked up a manual oil pressure gauge before I installed my...

I changed out my oil pump while I was in there too , after reading and hearing from different people that around 150k miles the oil pumps have had some issues which at least three friends confirmed their pumps showing the signs of wear and tear. Mine wasn't didn't have quite that many miles yet...

Running a Pioneer AVH 7700 BT, love it.

Are the earlier TJ hardtops with the exhauster vents in the side known for water leak issues by the vents?

I installed a ARB air locker in my Dana 35 , and the Tech's at ARB recommended an axle truss for the Dana 35. So I went with a TnT axle truss .

Chris , with your Currie Correct lync did you use a dropped pitman arm?

Thanks

We're the older 4.0 '97- early distributor '99 prone to cylinder head cracking?