Recent content by jws123

Ok thanks I see some people just get adjustable uppers Or should I do both? As for the shaft I have a local drive shaft shop that can do it I just wanted to get the lift/setup correct before touching the drive shaft.

I have a 2002 jeep TJ with a 3 inch rough country lift and a 2 inch body lift as well as a 1 inch motor mount spacer It came this way. I blew my transfercase and since the angles where never right ect. I decided I wanted to install a SYE and do it right So I picked up a tcase with one installed...

I cheaped out I ordered a Used shaft on ebay for 100 buks and new seals for 30 buks. I was between that replacing the tcase with used one they all appear to be $300-500... or installing the slip yoke again kit with driveshaft $600 I just use this thing around town for now doesnt see the parkway...

Thanks for the info I will count the splines to confirm.

from what I understand all jeep tj Manual 4.0 tcases are 23 tooth. 4 cylinder is diffrent what i was trying to find out is if i can put a tcase from a auto jeep 23 tooth Into my manual 5 speed have some cheap ones in my area.

Disregard the post above I now see that you cant put a tcase from a manual jeep into a auto. However getting conflicting posts about auto tcase going into a manual it sounds like some people got it to work since its not sealing anything?

I am looking up used 231 Tcases it is showing Long and Short input shaft? whats the diffrence they look the same in the pictures at least Is one auto or manual?

Btw the rattle isnt the tcase its my shitty exhaust.

Well after many many trials and errors I decided to pull the rear driveshaft and put it in gear The output shaft on the Tcase is bent like a Taco Il upload a video shortly.

Yes its shot i got new cables waiting on a new bracket.

Motor mount lift made the angle look a bit beter nevertheless it didnt help. Im dropping the tcase more tomorrow

Yea im going to head to tractor suplpy and get a handfull of washers my Motor mount lift comes tomorrow hopefully i can get it driveable. On a side note I have 1 key does anyone know a way to pull a key pin alpha obd ect everything i usually use doesnt work because its to old My scanner can...

I dont remember there being much slop but I will check tomorrow.

they are brand new it was the first thing i did today It cant be a balance issue with this severe of a viberation i cant even get past 20 mph.

After a ton of searching I noticed this thing doesnt have a motor mount lift I ordered one hopefully it will help enough to get things into adjustment. Im already to deep into this jeep to do a SYE ect I see a kit for $550 with a driveshaft but idk... I talked to the old owner he said he only...