Recent content by Kushneap

At this point I’m uncertain about everything lol. The outer shaft ears had a very difficult time getting both C-clips in for the same reason as the stub shaft. I can get one c-clip in but when I press it through the other side I never get enough clearance for the 2nd. And as I stated there are...

May be what I do. Hopefully not too pricy. Under 150 would be great

The stub shaft yes. Only that part

Anyone have suggestions for a good replacement for the outer axle shaft. 2000 TJ SPORT Thanks

Sounds good! I’ll torque them down and see where I stand. Appreciate the feedback.

So that gap is Meaning that gap is okay? I know they are tapered studs but I thought I’d get it a lot closer than that.

Spicer and I haven’t tightened them yet

I have installed new upper and lower ball joints to my 2000 TJ. As you can see the ball joint shoulders are seated firmly against the C. You can also see that the knuckle is NOT firmly against the rubber of the ball joint. Why won’t this seat firmly against the ball joint? Help me...

Thank you

Don’t I know it. May take you up on those knuckles

Slight nick on the C, worries?

Lol. Let me see what I can do to restore them first, sorta a hobby for me. If they turn out terrible, I’ll absolutely be in touch with you sir. Thanks and I appreciate the help thus far.

I think I’ll go here More room than above the nut

I got you. The ball joint stud on top the of the knuckle. Will do. Any suggestion on a cutting disk best for it?

Basically cut off the stud that’s showing or cut the castle nut itself?