Recent content by Lowlife

Would you still recommend them?

👍👍

I’m thinking I will just change the motor. If nothing else that will be all new and last longer than I will. Best recommendations for replacing with a stock motor?

No I didn’t went cheap. It started smoking when I ran seafoam through it. The intake manifold Was extremely gummy. The ticking got worse all of a sudden as well. I’ve tried a bunch of additives and different oils. Lost power as well and it started ever so slightly missing. Just barely can...

240,000 miles, I replaced the lifters, push rods and rockers. What do you all think? Sounds like it’s in the lower end maybe wrist pin or bearing, etc. Time for a rebuild? Recommended replacement manufacturers? J&S in Spokane?

Yet another good write up. Thank you. My radiator just went on the way home from work.

I should have added I’m not the original owner. When I got them out they just crumbled. U joint were the same way. I believe the Jeep was a tow vehicle behind an RV at some point. Honestly I was chasing down death wobble and this was on the list. It needed done but I think the actual issue...

I borrowed the set from autozone last week and it worked perfectly. Be ready for the pop and follow the video and it is pretty easy. I have well over 200000 on mine and it was time. Did ball joints wheel bearings inner seals and u joints. Seals were a little tricky but we came up with a...

Thank you jerry. I really appreciate all the knowledge you guys share on here it helps us amateurs more than you know.

I haven't checked it after I replaced the tie rods. I drove it around the block a little and back then checked the ball joints and I figured with the amount of movement that would be my next thing to replace. With the mileage and I don't think much was done to keep it up it was time to just...

I noticed the front wheel wobbling and got a shimmy in my steering wheel. So after much forum reading started with tie rods. That has eliminated the shimmy best I can tell. But now when driving it goes left or right with and little bump or anything, basically continue to fight to keep it...

My ball joints are bad. I'm going to replace them. Question I have is what else should I replace while I have it apart? 1. Ball joints 2. Wheel bearings 3. U joints 4. Axle seals It's got over 213000 miles so I figure it's time I feel like I'm missing something I just put on a crown tie...

Fellow vet of desert storm. I was in commo, attached to arcent and supported the liaison with Saudi 10th division, 5th special forces group and some marine unit. Lived in Waco for a while working about 10 years ago.

Guy I work with name is Klinton is also on here. He's from up by Lyons.

Bare with me I'm new to this