Recent content by MRChiefE7

We also have the JKS 3" JSPEC Suspension System on our 2005 LJ with 33"x12.5". I liked the fact that it has everything you need.

LitleTankTJ, here is the information on my set up for flat towing. Base Plate: Blue Ox (BX1120) Tow Bar: Ready Brute Elite Break-Away: NSA Ready Stop Break-Away (RS-5000) Taillight: Bulb and Socket Taillight (BX8869)

Today when I got in the jeep, I am not getting only air from A/C vents only form the defrost. Would this be a Blower Motor Resistor problem or a vacuum leak? The is on a 2005 Jeep Wrangler Unlimited, 4.0, automatic.

How about JT Brooks ATD4 Automatic Tire Deflators.

Replaced the oil pressure sensor unit and replaced the transmission shift cable bushing.

I have used the Pennzoil in all the cars that we owned over the past 50 years

Got a couple of things done today. Replaced the valve cover gasket, changed the oil & filter. I still need the replace the oil sending unit that has been acting up. I was not able to remove the old sending unit. Need a deep socket that fits the sending unit.

Cleaned 6" of snow off the LT here in Virginia Beach, VA

Thanks for all of your input everyone. I will start with the MML and the skid plate and see how it goes.

Turned 80000 miles today.

I already have upper control arms installed in the rear from the JKS lift. I will try the MML along with the UFC skid plate and see what happens. I have had an Advance Adapter SYE on order already. It was to be shipped by 01/04/2022 but is now to be shipped on 01/22/2022. I may cancel it for...

No body lift installed.

I have the JKS 1" motor mount spacer already. So, I should be able to remove the stock skid plate and spacer and install the UFC skid plate and not need the SYE.

OK I have 2005 Jeep wrangler unlimited (LJ) with a JKS 3" JSPEC Suspension left with 33" tires. When the shop installed the left kit they added a 1" spacer to the stock skid plate. This has worked great so far but I have gotten hung up when off roading on the skid plate. So, my plan to remove...

Price reduced again to $75.00 OBO.