Recent content by muletownlj

2005 LJ Rubicon – 113600mi– Clean Frame – $18500 Clean Tennessee title in hand. Very clean and mechanically strong LJ Rubicon. • 115k miles • Automatic • Solid, clean frame • No accidents • Strong service history • WranglerFix PCM • OPDA replaced within 1k miles • OEM cam/crank sensors • New...

Hey everyone. I scanned my jeep for a P0155, and checked the O2 sensor voltage. Back to sensor one says low O2. Does this mean the sensor is bad, wiring or something else? Have a new Wrangler fixed ECM.

Hey there Good news on two fronts 1. You don’t necessarily need a drbiii to perform this. I have an autel MK808s and did the adjustment and relearn easily. I can’t vouch for things like snapon but I know the 800 and 900 series bidirectional Autel scanners work. 2. It’s really easy! I’m not...

Ouch. It’s just one so far.

Hey all I attempted to install some Fishbone sliders today . My 05 as a 1.25” JKS body lift. The person that installed it used new 4” long grade 5 bolts, not flanged so need a washer. Why would they do that?? The standard bolts are 3.5” and they added 1.25 so I figured they go for 5”… I...

Sounds logical. Sorry if I came across as gruff earlier, I tend to use the f work a bit freely. Appreciate everyone’s help!! Any other shock I should consider at the <$500 price point? I’m not going to do Moab or anything, mainly trails in middle TN. I have the DPG OME kit that comes with the...

Understood. I have DPG 2” extended bump stops front and rear.

I thought you were suggesting to also change the bump stops

I don’t want to f**ck with the springs. I just want to change from the way too stuff OME sport shocks to something wiht a softer ride.

That’s the exact opposite of what @Jerry Bransford just said. I really just want to get one of the kits that are plug and play

https://www.amazon.com/dp/B01GY25HVE/?tag=wranglerorg-20 Ok so this one for the 2.5” coil lift then? Any other supplier you’d suggest?

@Jerry Bransford has then I think…

Hey to follow up Swapped OPDA. After I used the Autel to actively monitor the cam/crank angle. It was at 10.5 degrees despite installing the OPDA at TDc. I loosened the nut holding the OPDA and twisting the assembly until it was at 0.2. Tightened down and did the cam/crank relearn (YES IT...

Hey gang My 06 LJ has a 2.5” OME coil lift and a 1.25” body lift. Do I need to take the body lift height into account when purchasing shocks? Think I’m going with Rancho rs5000x. They have a 2-3” set but with the body lift im at 3.25” I daily drive it so need something good on the every...

I have a feeling nobody has specific experience with this unit and I haven’t found a lot of information on others. My other idea was to buy a DRb unit. and use it for what I need - then rent it on the forums for a small fee with a deposit just to recoup the cost. There’s a sketchy looking...