Recent content by phacor8

When I did mine, I stared at it for what seemed like forever. It took a lot of nerve to make the first snip, I was sure the entire time I was cutting the wrong wire, and I'd never be able to get the jeep to even start

I've thought about it, or doing a wrap like Boogie suggested. Sand and some sort of 2k clear in a can? I guess that would be better than nothing

South Florida sun on my 2005. I'll have it repainted one day, for now I comfort myself by calling it a patina

That is the laziest paint job I've ever seen. Didn't even bother to take the soft top off first...

The defroster film won't lift off as well when removing the tint?

The tint on my rear window is bubbly and needs to be replaced. The defroster film also has seen better days, and one of the tabs is broken. Not sure of the better option- should I be looking at just replacing the tint, tint and new defroster film, or buying a whole new rear window?

I ordered a sailcloth rat for my TJ this past fall and the fit is pretty spot on.

05-901 is their gold series product, supposed to have higher clamp load and torque handling. Could be used, but not necessary.

Replaced passenger side front axle shaft. Was leaking gear oil recently, replaced the inner seals, same side was still leaking. Hopefully this takes care of it.

Both the valve and damper. Visually identical, except for the added valve.

I bought a used Mopar rail on eBay that had the Schrader valve. I think it was listed as 2000-2004 4.0 fuel rail. Looked exactly like my oem 2005 rail, only difference was the Schrader valve

Nobody has to believe it, but I have the same experience. So you are not alone

I put 125k on my oem radiator, still working when I decided to refresh my cooling system and changed it out for another Mopar

There is a clip that slides in at the top of the injector, then hooks onto the rail. You should be able to just pull it out of the rail if you wiggle it. If not, use some needle nose to gently spread open the clip

Trying to think this through, but I that was normal behavior with a non programmed key when skim is present?