Recent content by RetiredJim

3.5" Metalcloak lift w/ adj upper and lower arms SYE Adams rear drive shaft 35" KO2's 32RH trans stock height Brown Dog motor mounts 1) no vibration added G2 Dana 44 rear axle w/4.88 gear and 4.88 gear in the front Dana 30 2) vibration started at about 55 - 60 I tried: 1" T case drop (removed...

No nuts on the half doors on my 2001. Take them off occasionally, no problem.

I have the Hyline holding a 35 x 12. I’ve had it on more than two years. Zero problems.

X2 on Bedrug. Good fit, easy to remove and clean. Sent from my iPad using Tapatalk

4.88, 35” KO2’s, 3sp auto, 3.5” lift. I get 11 mpg when I use it as my daily driver. Sent from my iPad using Tapatalk

What is your caster angle? Sent from my iPad using Tapatalk

Is your front axle an HP 44? Sent from my iPad using Tapatalk

Has anyone with a HP30 or HP44 front axle reported vibration problems? I'm tempted to try this. With my front driveshaft disconnected there is a significant improvement.

X2 on Bartact. They are great.

I have been fighting a very similar problem. With the rear driveshaft removed and my caster at 4.9 I still have vibes driving in 4W hi. I'm considering two options 1. 1" MML - Won't this make the front driveshaft angle worse? 2. High pinion Dana 44 axle - it seems like this may help a great deal. If...

I have: 4:88 3spd auto Metalcloak 3.5 lift 35" tires Harmonic vibration Sent from my iPad using Tapatalk

I have a very similar vibration and have tried most of the same adjustments. I have a Dana 30 in the front with 4:88's. I'm thinking about swapping the front axle for a hi pinion HP44 in an effort to get less angle on the front CV. I'm looking for a comparison of the pinion height between the two...

I get 0740 from time to time in my 01TJ . Fluid and transmission operation are all good. Sometimes it clears for a month. The trans was rebuilt 2 yrs ago. I'm convinced it is an electrical connection. Sent from my iPad using Tapatalk

I had the sticking brake problem on my 01. Although I changed rotors and calipers the culprit was the flex hose. The interior had deteriorated and and crap in the line was blocking it. Sent from my iPad using Tapatalk

Check that the unit Make sure you have a solid ground connection from the unit to the body.