Recent content by Sam410

Wish I could help but im down in SD. Dont know the Ventura area

Id start at the terminals. Clean them real good with one of those auto part store terminal brushes

Nice Jeep! Super clean. this jeep is also very nicely spec'd. from the looks of it, that soft top was never opened and was part of the dual top option. Word of advice on that, dont sell the hardtop! they have shot up in price recently. I used to buy/sell them around 300-400 bucks around 5-6...

I have an aftermarket bumper with a hitch for towing a small teardrop trailer. it's around 1200lbs. I replaced the bumper hardware with grade 8 bolts and added the barnes 4x4 frame tie ins. Super solid.

Just dropped a shop talk video breaking down a strong, locked dana 30 build for less than 500 bucks This setup centers around V8 ZJ CV shafts, ZJ Tie Rod upgrade and a spartan locker. No RCVs or ARB lockers around here. If you daily or trail your Jeep on the weekends and want performance...

As others mentioned, noise level isn't bad at all. the slight swoosh noise is accurate.

Absolutely. My intention was to free up as much space on the fender as I can. As far as hydrolocking, Im diligent about keeping my cowl/cowl drain clean. Remember, the hvac intake is there too (lots of folks get wet passenger floors) so I consider checking the cowl drain routine maintenance...

Thanks!

Hello! I just finished putting together my DIY cowl intake and am very happy with the result. I used a ford windstar air intake filter housing I got from the pick and pull and a 90 degree reducer I got off amazon. All in... about 60 bucks! I loosely followed this post from wrangler forum...

I just uploaded my first YouTube video documenting where my TJ build is at. It dawned on me how many TJ YouTube videos I've probably watched over the years and that people would probably watch the shenanigans I get into wheeling and building... Just have to set up the camera. The build is...

Wow I really like the look of your seats. Any more info on them?

I will be wheeling the Pinyon Mountain Trail tomorrow if anyone is up to go.

No nothing id do differently. It a very nice setup. Get a good cable shift kit. I ordered my driveshaft from Tom Woods as well, no complaints there they're great folks.

I lucked out! I was not looking forward to cracking open the T case again.

UPDATE I spoke with the folks over at JB Conversions this afternoon. First and foremost, I do not want this post to steer people away from them in anyway. They were quick to answer my questions and are sending the correct rear housing, tone ring and sensor. To answer the original question I...