Recent content by TeamJim

No problem. It's a little frustrating finding out this was the problem all along (and that I missed it initially), but hey, it's got a fresh solenoid pack, a shift kit, and the fixed PCM now so I feel like it should be good to go for a while :LOL:

Well, after going over the wiring again, I found my problem. The two wires going to the output speed sensor were broken, one of them completely. I missed it before because I pinned the connector and had continuity between the connector and the harness plug, so I didn't think to pull the loom off...

Yeah I'm going to pour over the wiring again. Where is that section of chafed wires at? Codes are p0700 and p0731.

It's all in the first post. Hanging between 1st and 2nd, then shifting into 2nd hard and going into limp mode. No intended animosity towards you, if it came off that way. I'm just frustrated that my Jeep has basically been sitting since October ☹️

Well, installed my new PCM from @Wranglerfix today. Still having the exact same issues. Guess it's transmission rebuild time. Either that or burn this damn thing to the ground time 😆

@Wranglerfix I'll be giving you a call soon. What days and times are you available/your business open?

I've thought about that. I've just not seen anyone with specifically these issues solved with the TCM. Worth noting that the fluid looked clean when drained, wasn't burnt or discolored. No debris in the pan, very little/normal amount of very fine metal on the magnet. Makes me think it's not an...

I've searched through and haven't been able to find someone with the same issues I've got. 2006 X, 42RLE, ~150k miles, 35s, 4.88s, correct speedo gear. Issue I'm having: the Jeep sat for a few weeks. Went for a drive and it flared on the 1-2 shift, then dropped hard into 2nd, and went into...