Recent content by Wingryder

This is old but... I have not broken mine yet.. however I liked the hole saw idea.. but why cut two holes?. One in the middle should let you chisel or dremel out old nuts and install new ones. You could then patch the hole with a body plug. The very thing the factory should have done.

Thanks to all. I raised the jeep body with floor jack . That dropped the tires down out of the way. Pried the inner fender up and with a good light and long squirter hosed those bolts good. I will do this for several days.. (daily driver) and tenderly sneak up on them when I have the...

Stock 97 needs shocks soon. I have read the horror stories about breaking the rear upper bolts. How do I get to them to presoak ? Do you remove rear inner fenders or can you get to it some other way.? Leaning toward drilling some "oiling" holes in the deck above the shock mount.

Dont fight that wire/cable. Loop top end of cable over post. Let it hang behind backing plate. Finish up everything else. All springs in place. Now bring the adjustment cable down (not over curved guide yet) Attach at bottom. Then swing that lower assembly up with your thumb for maximum...

Sorry LHC30 I have to withdraw my support. Just talked to Mechanic.. The hole is over sized so it will not bind but slip around the post even though there is side tension from spring ends. To fix over lenght.. be sure curved guide is in correct and then if necessary you can carefully open...

@LHC30 you are right. Why would the top end of that adjust cable have that great big hole in it only to go over the narrow part of the post. ? And that leaves the cable too long. That mismatch of big hole over small mounting post... has bothered me everytime I see it. including my 97 which...

Thanks for quick replies. Just the info I was needing. Now to work.

My 97 TJ Sport with 4.0 needs a fuel pump. Gathering parts and info to be ready for a warmer spell. I do have a Bosch 69313 kit coming which I may or may not use. I am also considering the complete pump assembly with the Delphi product. First question.. I see both the FG1353 and FG1355...