Recent content by Wralabamangler

Did that yesterday. Got put on hold and eventually told that I would have to "drill holes in the tub and use big washers." They were polite, but to be honest, I wasn't impressed with their technical knowledge, at least on this particular application.

Could I not just use this adapter, drill holes through "bottom" portion of the mount to align with the factory tub holes? If so, I'm guessing it would provide minimum elevation, so I still might need to fab a mount similar to LJGreg's ro raise the seat slightly. Thoughts?

Late to the game, but how does the PRP rear bench bolt in? The PRP website shows adapters for front seats, but I see none for the rear bench.

Unplug your hoist, then open your controller. More than likely the controller is closed using small screws. Once you have it open, check to see how the control wires are connected to the controller itself. If they're connected via male/female plugs, it's an easy change. Buy the appropriate...

That happened to be playing on Pandora's Jimmy Buffett channel. And no, it's not JB. LOL

I used something called a round floor brush grommet. They're available all over the internet. I installed a 5 inch to allow the hoist cable height cutoff to pass through, though I don't intend on ever raising the cable that high. Since the grommet screws into the drywall, I reinforced the...

Not today, but over the past four months On 11/30/20 I flew to Cleveland, OH to test drive and purchase an ’04 TJ Rubicon with 25,000 miles on it. I arrived in Cleveland just before the first BLIZZARD of the year. Test drove the TJ on 12/1 in a foot of snow, made the purchase, then began the...